Laserfiche WebLink
GENERAL INFORMATION <br /> The complete lack of moving parts of this insertion flow SPECIFICATIONS <br /> i <br /> sensor,is the source of its reliability. There is no rotor to <br /> stop turning in dirty water and there are no bearings to PO E 12 - 24 Vdc, 250 mA <br /> wear out. A rapidly reversing magnetic field is produced <br /> FLOW 7ANGE 0.2 - 20 ft/sec <br /> + in the lower housing, and as the fluid moves through this <br /> field a voltage is generated. This tiny voltage is measured INSTAL TION <br /> and translated into a frequency signal which is proportional <br /> to flow rate. This square wave signal can he sent directly <br /> FIT N SIZE EX101, 201: 1.5" MNPT <br /> EX115, 215: 2" MNPT <br /> to a PLC or other control, or can be converted using any of <br /> the SeaMetrics family of indicators and convertors. TE PE ATURE Ambient: 0 - 180 F <br /> � Fluid. <br /> 32 - 212 F <br /> i A modular system of electronics can be attached directly PR SURE 200 psi <br /> k to the flow sensor, or remotely mounted. SeaMetrics <br /> i3 currently offers four systems: The FT420 provides full MIN MUM CONDUCTIVITY 20 microsiemens/cm <br /> E indication of rate and total, plus 4-20 mA output. The i <br /> 4-20 mA output, the PD10 divides CALIBRATION ACCURACY 1% of full scale <br /> k A055 provides blind p , <br /> the pulse frequency, and the FS30 can be used fora OUT UT Square wave pulse, <br /> precise setpoint flow switch. Opto isolated, <br /> 500 Hz @ 20 ft/sec <br /> jia <br /> The installation fitting of the EX sensor is standard male 81-D R CTIONAL Direction output, <br /> NPT, and can be directly threaded into ordinary saddles or Opto isolated <br /> threaded weld fittings. The EX115 and 215 include an <br /> isolation valve, allowing hot-tap installation, or installation EM TY PIPE DETECTION Software, defaults to <br /> and removal under pressure. The standard isolation valve i zero flow <br /> I is bronze, but a 316 stainless steel valve is available as <br /> an option if needed. <br /> E 1Q0/200 SERIES PARTS DIAGRAM <br /> co' r or Module <br /> ! I 1 <br /> Housing Screw (connect ground to one): i <br /> Cable-Seal Strain Relief <br /> Lower Housing T. <br /> Shaft <br /> Threaded Adaptor - Nip <br /> � a <br /> ` Sensor— N m Page 1 <br />