Laserfiche WebLink
FILTER ASSEMBLY <br /> 1. Replace plugs or close valves in Tank Drain and Auxiliary Drain ports. <br /> 2. Push clean air bleed filter all the way down on tube. If tube has been removed, push <br /> it into socket seat in base until it bottoms. <br /> 3. Set filter element on base. <br /> NOTICE: Be sure blue end marked "TOP" is on top and orange end is on bottom. Do not <br /> reverse element. <br /> 4. Push filter element into base between two circular ribs until it bottoms. <br /> 5. BE SURE "O" Ring sealing area of tank body is clean. Clean "O" Ring and check for <br /> damage. Replace if necessary. <br /> 6. Lubricate "O" Ring with approved lubricant (see chart) and place in seat. <br /> NOTICE: Top and bottom clamps and "O" Rings are not interchangeable; DO NOT mix <br /> them up. <br /> CAUTION: Do not remove or damage safety and instruction lables during cleaning. Re- <br /> place any decals which may have been damaged. <br /> 7. If bottom clamp was removed, BE SURE bottom of tank body is clean; set tank body <br /> evenly on base and "O" Ring. <br /> 8. Install clamp(s) and knob assembly(s); tighten knob(s). To assist sealing, tap clamp(s) <br /> around tank with hammer while tightening knob(s). <br /> 9. Clean pump strainer basket. <br /> 10. Open system valves as needed. <br /> APPROVED O-RING LUBRICANTS <br /> Petroleum Jelly (Vaseline) Semi-Permanent Lubrication <br /> Parker Super-0-LubeSemi-Permanent Lu rication <br /> qua u e by AllubeSemi-Permanent Lubrication <br /> 5% or less Mild Soap Solution Assembly Lubrication <br />