COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

SECTION 7) HANDLING AND STORAGE General: Wash hands after use. Do not get in eyes,on skin or on clothing. Do not breathe vapors or mists. Use good personal hygiene practices. Eating,drinking and smoking in work areas is prohibited. Remove contaminated clothing and protective equipment before entering eating areas. Eyewash stations and showers should be available in areas where this material is used and stored. Ventilation Requirements: Use only with adequate ventilation to control air contaminants to their exposure limits.The use of local ventilation is recommended to control emissions near the source. Storage Room Requirements: Keep container(s)tightly closed and properly labeled.Store in cool,dry,well-ventilated areas away from heat,direct sunlight,strong oxidizers and any incompatibilities.Store in approved containers and protect against physical damage. Keep containers securely sealed when not in use. Indoor storage should meet OSHA standards and appropriate fire codes.Containers that have been opened must be carefully resealed to prevent leakage. Empty container retain residue and may be dangerous. Use non-sparking ventilation systems,approved explosion-proof equipment and intrinsically safe electrical systems in areas where this product is used and stored. Store in tightly sealed containers to protect from atmospheric moisture.Store in a cool dry area.Store liquid in containers above ground and surround by dikes to contain spills or leaks. Ground and bond containers and receiving equipment.Avoid static electricity by grounding. SECTION 8) EXPOSURE CONTROLS/PERSONAL PROTECTION Eye Protection: Wear eye protection with side shields or goggles.Wear indirect-vent,impact and splash resistant goggles when working with liquids. If additional protection is needed for entire face,use in combination with a face shield. Skin Protection: Use of gloves approved to relevant standards made from the following materials may provide suitable chemical protection: PVC, neoprene or nitrile rubber gloves.Suitability and durability of a glove is dependent on usage,e.g.frequency and duration of contact,chemical resistance of glove material,glove thickness,dexterity.Always seek advice from glove suppliers.Contaminated gloves should be replaced. Use of an apron and over-boots of chemically impervious materials such as neoprene or nitrile rubber is recommended to avoid skin sensitization.The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.Launder soiled clothes or properly disposed of contaminated material,which cannot be decontaminated. Respiratory Protection: If engineering controls do not maintain airborne concentrations to a level which is adequate to protect worker,a respiratory protection program that meets or is equivalent to OSHA 29 CFR 1910.134 and ANSI Z88.2 should be followed.Check with respiratory protective equipment suppliers. When airborne concentrations exceed or are expected to exceed the TLV,use MSHA/NIOSH approved positive pressure supplied air respirator with a full-face piece or an air supplied hood. For emergencies,use a positive pressure self-container breathing apparatus. Appropriate Engineering Controls: Provide exhaust ventilation or other engineering controls to keep the airborne concentrations of vapors below their respective threshold limit value. Chemical Name OSHA OSHA OSHA OSHA OSHA OSHA NIOSH NIOSH NIOSH NIOSH TWA TWA STEL STEL Tables(Z1, OSHA Skin TWA TWA STEL STEL NIOSH (ppm) (mg/m3) (ppm) (mg/m3) Z2,Z3) Carcinogen designation (ppm) (mg/m3) (ppm) (mg/m3) Carcinogen CARBON BLACK 3.5 1 3.5a 1 SILICA, a [10 mg/m3 [1,3];[3]; 0.05e 1 CRYSTALLINE percent Si02+2/ 250 percent Si02+5 mppcf];[30 mg/m3 percent Si02+2]; Chemical Name ACGIH ACGIH ACGIH ACGIH TWA TWA STEL STEL (ppm) (mg/m3) (ppm) (mg/m3) UL KG 3607, B-Side www.UltimateLinings.com Page 4 of 8