ARCHIVED REPORTS LEC APPLICATION FOR CERTIFICATION

Home Browse Search

® WorleyParsons resources&energy conditions of each application as listed in the Data Sheets. The valve body size will not be less than two pipe sizes smaller than the nominal inlet pipeline size, unless otherwise specified. Bellow seal bonnets will be used for highly toxic or volatile fluids. Teflon or approved non-asbestos alternate packing material may be used for temperatures between -40°F and 450°F. Grafoil packing will be used as a minimum for temperatures 450°F and above. Solenoid valves supplied with the control valves will have Class H coils 120 VAC UPS powered. The coil enclosure will normally be a minimum of NEMA 4 but will be suitable for the area of installation. Terminations will typically be by pigtail wires. 5.6.6.1 End Connections Steel valves with flanged ends will be in accordance with ASME B16.5. End to end dimension of each valve will be in accordance with the appropriate ISA Standards (i.e. ISA 575.03 and S75.04). All welding connections for valves 2-1/2 inches and larger in nominal size will be butt- welded. All welding connections for valves 2 inches and smaller in nominal size will be socket welded. All welding ends will be in accordance with ASME B 16.34 and B 16.25. Control valves in 300# class service and below will be flanged, except for Hydrogen, Natural Gas, Ammonia, steam and vacuum service. Where flanged valves are used the flange rating will match the pipe class specifications. All control valves 600# and greater will be furnished with weld end connections. For butterfly, ball, and similar body types, lugged or flanged bodies to permit dead end service will be provided unless otherwise specified. Wafer types that cannot be independently fastened to the field piping at both ends of the valve body will not be provided. 5.6.6.2 End extensions and Reducers: If the size of a welded end valve is different than the field pipe size, the valve will be furnished with shop welded concentric reducers matching the upstream and downstream pipe size, material and wall thickness. Shop welded end extensions will be provided for valves with body material that is different than the field piping material (such as alloy valve bodies to be welded into carbon steel pipelines or vice versa). End extensions will be a pipe section at least 6 inches (150 mm) long. End extensions and reducers will be factory installed on the valve body and stress relieved in accordance with ASME B31.1. End extensions and reducers will be shown on the valve drawing and included in the shop end- to-end or center-to-face dimensions. Lodi Energy Center 3.5- 10 LEC AFC 071608 Rev.A