INSTALL 2019 TANK TOP UPGRADE - Laserfiche WebLink

Home Browse Search

ITEM#149 Veeder-Root TLS-350 Monitoring System Requirements for CPM Consoles: (Must be equipped with an ECPU2 or an upgrade is required) Continuous Pressure Monitoring: • Veeder-Root TLS-350 • Veeder-Root TLS-350R Low Investment. Big Return. • Veeder-Root TLS-350 Plus A few minor equipment additions to the TLS-350 platform such as a pressure • Gilborco EMC sensor,a smart sensor module and memory expansion allows CPM to provide • Red Jacket ProMax two primary solutions.First,Continuous Vapor Leak Detection(CHH is a Memory Board: (332966-203) solution within CPM that informs station owners of the compliance status of the • A flash memory board(NVMEM 203)for software storage-installed on the ECPUII vapor containment system,whether the ulloge space is pressurized or under board in place of the console's 1/2 Meg RAM board-install as per TLS-350 Series vacuum.This feature within CPM will provide discreet alarms if performance Board and Software Replacement Manual,no setup required. drops below the required compliance level,informing station owners that the vapor space is leaking.Second,Pressure Monitoring continuously examines the Communication: pressures within the fuel tank storage space and reports on a daily and monthly • A RS-232 module is required for RS-232 access to CPM reports-install as per basis the percentage of time above the pressure limit input and the percentage of instructions shipped with module. time above atmospheric pressure.The pressure limit input is calculated manually Probes: by testing the P/V valve and input into the CPM system at 0.5"WC below the • One V-R Mag probe in each of the gasoline tanks being monitored-install as per site-determined cracking pressure. installation manual shipped with device,setup following instructions in TLS-3XX Setup Manual. Pressure Monitoring �— (P/V Venting) Smart Sensor Module:(Either 7 Channel:332250-001 or 8 Channel:329356.004) Pressure Sensor • Smart Sensor module is required to monitor Vapor Pressure Sensor(up to 8 devices per Enclosure module,or 7 9 customer is using SmartSensor module/embedded pressure).Install and connect following instructions in the Vapor Pressure Sensor installation Guides. continuous vapor Leak Detection Pressure Sensor:(330020-630) ; • Vapor Pressure Sensor(one per site)-install as per Pressure Sensor installation manual shipped with sensor. Software Enhancement Module (SEM) (330160-XXX) • Activates CPM software technology compliance information,obtain inventory and delivery information,and access site history and analytics. Stage II Decommissioning Options&Manual Test Schedules Option At Time of Monthly Quarterly Annually Every 3 Years Decommissioning Install(PMPressure Decoy Test None None None DecayPressure (Per EPA NESH Inspect fill and Stage I Swivel adapters to be sure If the annual test is Pressure Decay Test they are tightly sealed. failed(meaning (without any Visually inspect Stage I dry breaks to be sure corrective action was corrective action they are tightly sealed. needed on the day of taken before or Decommission Pressure Decay Test the test),quarterly during the test on the Pressure Decay Test without CPM Check ATG caps to be sure they are tightly sealed and that testing shall be required day of the test)and a (Per EPA NESHAP 6C) the associated electrical grommets and vent extractor caps and annual testing shall P/V valve test. are in good working order. resume upon passing four(4)consecutive Visually inspect the Riser and P/V valve and cap for damage quarterly tests. visible from the ground level. To learn more,contact us at 888.561.7942 or visit www.veeder.com 125 Powder Forest Drive, P.O. Box 2003,Simsbury, CT 06070 USA,©2015 Veeder-Root Company �`� VEEDER—ROOT