Laserfiche WebLink
Veeder-Root Sensor Application Guide <br /> Sump Sensor <br /> The sensor is installed in a tank piping sump and will detect the presence of a liquid. Liquid level is monitored by a <br /> float/magnetic reed switch sensing system. <br /> Sensor Detection Capabilities - Alarm Conditions <br /> • Fuel alarm is triggered when liquid reaches a nominal height of 1-inch. <br /> • An open sensor triggers a Sensor Out alarm. <br /> Operating Capabilities <br /> • Operating temperature range: 0 to+60°C. <br /> • Storage temperature range:-40 to+70°C. <br /> • Sensor dimensions: 12" high, 1.9"diameter- <br /> Sensor/Cable Length Configurations <br /> • Sump Sensor w/ 12 foot cable- Form Number 794380-208 <br /> • Sump Sensor w/30 foot cable- Form Number 794380-209 <br /> Sensor Interface Module <br /> • TLS-350 Series Consoles(except TLS-350J)- Interstitial/Liquid Sensor Interface Module (P/N 329358-001) <br /> accepts up to 8 sensors (a maximum of 64 sensors could be monitored by the console). <br /> • TLS-350J Console- 3 sensors max. <br /> • TLS-300/PC-300 Series Consoles (no Interface Module required) -8 sensors max. <br /> • ILS-350 Console-A Two-Wire Module (P/N 329675-001) accepts up to 4 sensors (a maximum of 16 sensors <br /> could be monitored by the console). <br /> Console Software Compatibility <br /> • Version 1 or later(TLS-350 Series/TLS-300 Consoles) <br /> • All ILS-350 Consoles <br /> Compatible Fuels <br /> • Unleaded gasoline DO NOT MOUNT SENWR To - Existing Conduit <br /> • Unleaded with up to 5%methanol, FLEXIBLE PRODUCT or piping 1 <br /> 15%ethanol,or 15%MTBE <br /> • Leaded gasoline <br /> • Dieseld�Product <br /> • Kerosene Cabe to junction boxes Cable to junctio pipe <br /> • Jet fuel and saal-off box and seal-off 1 <br /> • Aviation gasoline ? <br /> Related Sales Literature "Sump sensor should: 1,; ,. <br /> 1.Rest on the base of the sump. "`">`' tx`r <br /> Visit our website at www.veeder.com 2.Be posWoned as close to outer Oz.. <br /> Sum <br /> for more information an Veeder-Root wall as possible. �'�''�:;. p sensor <br /> 3.Be mounted in a true vertical (installation examples) l9:� <br /> products and services- -tFr`' <br /> p position. <br /> 4.Be installed only in a dry sump. <br /> ;yy `i_. <br /> Fig.2 Typical Sump Sensor Installation <br /> mp base - <br /> 5 <br />