Laserfiche WebLink
Y <br /> woA <br /> F � <br /> ice+ <br /> iW. <br /> APPENDIX B <br /> KLEINFELDER FIELD PROTOCOL <br /> B-1 FIELD PREPARATION <br /> Before performing work in the field, environmental staff review the scope of work,prepare <br /> a health and safety plan, coordinate the work to be done with their supervisor, assemble <br /> the necessary sample containers, and check, calibrate and clean equipment to be used in <br /> r the field. When underground utilities may exist at a site where subsurface soil samples are <br /> " being collected, USA Underground is contacted with the boring locations and the <br /> scheduled date of drilling, or a utility locating firin is employed to check the boring <br /> .». locations. <br /> i <br /> B-2 SUBSURFACE SOIL SAMPLING <br /> B2.1 Drilling <br /> Subsurface soil samples are coLected from soil borings. Sorg borings are advanced using a <br /> track-mounted drill rig, equipped with 8-inch hollow stem augers. The borings can be <br /> advanced vertically, or at an angle up to 45 degrees from vertical. During drilling, an <br /> E ' experienced environmental geologist classifies the soil, logs the lithology and collects soil <br /> samples for laboratory analysis. A sample boring log form is attached at the end of this <br /> f.t appendix. <br /> B-2.2 Decontamination of Equipment <br /> To reduce the potential for crass-contamination, augers and associated equipment are <br /> steam cleaned prior to drilling each boring. In addition, sampling equipment is cleaned <br /> �ryf <br /> with a trisodium phosphate wash and rinsed with distilled water prior to collecting each soil <br /> = samDle- <br /> i <br /> r ; B 2.3 Cailection of Soil Samples <br /> G' <br /> Soil samples are collected approximately every 5 feet for field screening,lithologic logging, <br /> and potential chemical analysis. Samples are collected by advancing the boring to a point <br /> F6-FIELDPRO <br />