Laserfiche WebLink
Introduction <br /> This manual contains procedures for the installation or replacement of the following sensor interface modules: <br /> • Veeder-Root Type A Interface Module <br /> Part No. 329956-001 (with console) <br /> • Veeder-Root Type B Interface Module <br /> Part No.329950-001 (with console) <br /> • Veeder-Root Vapor Sensor Interface Module <br /> Part No.329357-001 (with console) <br /> • Veeder-Root Groundwater Sensor Interface Module <br /> Part No.329399-001 (with console) <br /> • Veeder-Root Interstitial Sensor Interface Module <br /> Part No. 329358-001 (with console) <br /> The above parts are for TLS 350 Series Consoles designed and manufactured by Veeder-Root.This manual <br /> assumes all preliminary site preparation is completed, and that field wiring from the sensor junction box to the <br /> console is in place. <br /> Contractor Certification Requirements <br /> Veeder-Root requires the following minimum training certifications for contractors who will install and setup the <br /> equipment discussed in this manual: <br /> Level 1 Contractors holding valid Level 1 Certification are approved to perform wiring and conduit routing, <br /> equipment mounting, probe and sensor installation,tank and line preparation, and line leak detector installation. <br /> Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation checkout, <br /> startup, programming and operations training,troubleshooting and servicing for all Veeder-Root Tank Monitoring <br /> Systems, including Line Leak Detection and associated accessories. <br /> Warranty Registrations may only be submitted by selected distributors. <br /> Related Manuals <br /> If site preparation or field wiring is necessary,you must refer to the following manual for installation instructions: <br /> 576013-879 TLS-3XX Series Consoles Site Prep and Installation Manual <br /> 1 <br />