Laserfiche WebLink
Page 10 <br /> IX. HAZARD MITIGATION <br /> Identify procedures to mitigate all hazards listed in Section VIII by placing the task number next to <br /> the appropriate mitigating measure. Listing of standard procedures is not inclusive A specific <br /> procedure must be entered to mitigate each hazard identified in Section VIII <br /> Activity <br /> List Number A. MECHANICAL HAZARDS <br /> 1 Do not stand near backhoe buckets, drill ngs and earth moving equipment <br /> 1, 2, 3 Verify that all equipment is in good condition. <br /> 1 Do not stand or walk under elevated loads or ladders <br /> NE Do not stand near unguarded excavation or trenches <br /> NE Do not enter excavation or trenches over S feet deep that are not properly <br /> guarded, shored, or sloped. <br /> 1,2 _ Consult SSO if any other mechanical hazards exist. <br /> B ELECTRICAL HAZARDS <br /> • 1 Locate and mark buried utilities before drilling <br /> 1 Utilities located by on <br /> 1 Maintain at least 10 foot clearance from overhead power lines <br /> 1 Contact utility company for minimum clearance from high voltage power <br /> lines <br /> 1 If unavoidably close to buried or overhead power lines, have power turned <br /> ofd with circuit breaker locked and tagged <br /> 1 Properly ground all electrical equipment <br /> 1 Avoid standing in or near water when operating electrical equipment <br /> 1 If equipment must be connected by splicing wires, make sure all <br /> connections are properly taped. <br /> 1 Be familiar with specific operating instructions for each piece of equipment <br /> NE NOT EXPECTED <br /> Parker Environmental Services, 4185 Rialto Court, Pittsburg, CA 94565-6116 <br /> Phone (510) 439-1024 Fax (510) 439-2566 <br />