Laserfiche WebLink
Product thickness is calculated by subtracting the depth to <br /> • product prom the depth to water In addition, water <br /> elevation, are adjusted for the presence of fuel with the <br /> following calculation. <br /> (Product Thickness ) ( . $ )+(Water Elevation) <br /> = Corrected V'-:ter Elevation <br /> Note- The factor of 0. 8 accounts for the density difference <br /> between water and petroleum hydrocarbons. <br /> New-Ly installed wells will be allowed to stabilize for 24 <br /> hours after development prior to free product inspection. <br /> a <br /> An acrylic Surface Sampler will be used for visual <br /> inspection of the groundwater in order -co note sheens <br /> ( difficult to detect with the Interface Probe ) , odors , <br /> microbial action and sediments. The sampler is calibrated <br /> in inches and centimeters fog visual inspection of product <br /> thickness. <br /> To reduce the potential for cross contamination between <br /> wells, the monitorings will take place in order from the <br /> least to most contaminated, if known. Wells containing free <br /> product will be monitored last. Between each well <br /> monitoring the equipment will be decontaminated. <br /> • Water level data collected from rhe wells will be used to <br /> develop a groundwater contour map for the project site. <br /> Groundwater flow will be estimated to be perpendicular to <br /> equipotential lines drawn on the map. <br /> 10.0 Well Development Protocol <br /> Groundwater monitoring wells will be surged and developed <br /> prior to setting the surface seal. Approximately 10 times <br /> the volume of water in the casing will be withdrawn if <br /> possible. Casing volumes will be calculated in the <br /> following manner: <br /> Volume of Schedule 40 PVC Pipe <br /> Diameter I.D. Volume <br /> ( inches ) ( inches) Gal/linear ft. <br /> ------------------------------------------ <br /> 2 2 067 0. 17 <br /> 4 x: .026 0. 66 <br />