ARCHIVED REPORTS_XR0002054 - Laserfiche WebLink

Home Browse Search

ATTACHM[EW A - ULTRAMAR FIELD PROCEDURES The following section describes procedures used by field personnel in the performance of ground water sampling at Ultramar Inc sites Ground Water Level and Total Depth Determination A water level indicator is lowered down the well and a measurement of the depth to water from an established reference point on the casing is taken The indicator probe is used to sound the bottom of the well and a measurement of the total depth of the well is taken Both the water level and total depth measurements are taken to the nearest 0 01- foot Visual Analysis of Ground Water Prior to purging and sampling ground water monitoring wells, a water sample is collected from each well for subjective analysis The visual analysis involves gently lowering a clean, disposable, polyethylene bailer to approximately one-half the bailer length past the water table interface The bailer is then retrieved, and the sample contained within the bailer is examined for floating product or the appearance of a petroleum product sheen. If measurable free product is noted in the bailer, a water/product interface probe is used to determine the thickness of the free product to the nearest 0 01-foot The thickness of free product is determined by subtracting the depth to product from the depth to water Monitoring Well Purging and Sampling Monitoring wells are purged by removing approximately four casing volumes of water from the well using a clean . disposable bailer or electrical submersible purge pump Purge volumes are calculated prior to purging During purging, the temperature, pH, and electric conductivity of the purge water are monitored The well is considered to be sufficiently purged when The four casing volumes have been removed, the temperature, pH and conductivity values have stabilized to within 10% of the initial readings, and the ground water being removed is relatively free of suspended solids After purging, ground water levels are allowed to stabilize to within 80% of the uutial water level reading A water sample is then collected from each well with a clean, disposable polyethylene bailer If the well is bailed or pumped dry prior to removing the minimum volume of water, the ground water is allowed to recharge If the well has recharged to within 80% of the initial depth to water reading within two hours, the well will continue to be purged until the minimum volume of water has been removed If the well has not recharged to at least 80% of the initial depth to water reading within two hours, the well is considered to contain formational water and a ground water sample is collected Ground water removed from the well is stored in 55-gallon drums at the site and labeled pending disposal In wells where free product is detected, the wells will be bailed to remove the free product An estimate of the volume of product and water well be recorded If the free product thickness is reduced to the point where a measurable thickness is no longer present in the well, a ground water sample well be collected If free product persists throughout the purging process, a final free product thickness measurement will be taken and a ground water sample will not be collected Ground water samples are stored in 40-milliliter vials so that air passage through the sample is minimized (to prevent volatilization of the sample) The vial is tilted and filled slowly until an upward convex meniscus fortes over the mouth of the vial The Teflon"` side of the septum (in cap) is then placed against the meniscus, and the cap is screwed on tightly The sample is then inverted and the bottle is tapped lightly to check for air bubbles If an air bubble is present in the vial, the cap is removed and more sample is transferred from the bailer The vial is then resealed and rechecked for air bubbles. The sample is then appropriately labeled and stored on ice from the time of collection through the time of delivery to the laboratory The Cham-of-Custody form is completed to ensure sample integrity Ground water samples are transported to a state-certified laboratory and analyzed within the U.S Environmental Protection Agency-specified hold times for the specified analytes