ARCHIVED REPORTS_XR0002644 - Laserfiche WebLink

Home Browse Search

KSVa ' A S S O C I A T E S I N C detected in the groundwater sample collected from soil boring SBI. The January 1998 subsurface investigation results are detailed in ATC's Summary Report for Subsurface Investigation, dated February 4, 1998. In September 1998, ATC supervised the excavation of approximately 70 tons of impacted soil. The soil was transported and disposed of at an appropriate landfill on the same day it was excavated. The excavation was limited on two sides by buildings and overhead lines. Confirmation samples collected from the excavation indicated there was residual contamination remaining. Also in September 1998, ATC supervised the advancement of four soil borings around the former excavation area. Three of the borings were completed as groundwater monitoring wells. Analytical data indicated the soil and groundwater at the site is impacted with total petroleum hydrocarbons as stoddard solvents (TPHss). The September 1998 subsurface investigation results are detailed in ATC's Summary Report of Soil Excavation and Additional Subsurface Investigation, dated December 3, 1998. SAMPLING ACTIVITIES On September 8, 1999, groundwater samples were collected by ATC Associates personnel from monitoring wells MW1 through MW3. The locations of the monitoring wells are shown on Figure 2. Prior to collection of groundwater samples, the depth to water, pH, electrical • conductivity, and temperature were measured in the monitoring wells and recorded. A minimum of three well casing volumes were purged from each well prior to sampling. The wells were allowed to recover and samples were collected from each well using dedicated disposable bailers. The groundwater samples collected from each well were submitted to State-certified Argon Laboratories (ELAP Cert. No. 2358) for chemical analysis of TPHg, TPHd, and TPHss utilizing EPA Method 8015 modified, and benzene, toluene, ethylbenzene, and xylenes (BTEX) utilizing EPA Method 8020. Groundwater well purge and sample logs are contained in Attachment 1. ANALYTICAL RESULTS The groundwater samples collected from wells MW1 and MW2 contained no detectable concentrations of TPHg, TPHd, TPHss, or BTEX. The groundwater sample collected from well MW3 contained TPHg at concentrations of 9,000 parts per billion (ppb). Although the groundwater samples from well MW3 contained detectable concentrations of TPHg, the chromatogram pattern did not match the pattern for gasoline. The groundwater sample from well MW3 also contained TPHss at a concentration of 2,800 ppb and detectable concentrations of toluene, ethylbenzene, and xylenes. Analytical results of groundwater samples are summarized in Table 2. Laboratory data sheets and chain-of-custody documentation are contained in Attachment 2. w:1172951quan1yl3gr-1999.doe 2