Laserfiche WebLink
I <br /> S E C 0 R <br /> Former BP Station# 11193 <br /> September 22, 2004 <br /> • Page 3 <br /> In February 1995, Alisto conducted baildown testing to determine aquifer properties <br /> beneath the site Pumping occurred from well MWA, generating approximately 1 5 feet of <br /> drawdown at an extraction rate of 6 gallons per minute (gpm) Alisto concluded that the <br /> rapid recovery may be due to the sand unit encountered in the l r'ro ioWHrt�°iavelfflI&-1, <br /> and may not be representative of the material in the saturated zone (Alisto, 1995) Revised <br /> calculations of hydrogeologic parameters were submitted in October 1995 Resulting <br /> hydraulic conductivity (K) values for wells MWA, MW-2, and MW-5 ranging from 2 25x10` <br /> to 8 68x105 centimeters per second (cm/s) were within the lower range of expected K <br /> values associated with the soil types encountered beneath the site (1 to 1x10-5 cm/s, <br /> Freeze and Cherry, 1979), which consist of sift and silty sand underlain by fine to medium <br /> sand (Alisto, 1995) <br /> Between December 10 and 22, 1998, Gettler-Ryan Incorporated (GR) supervised the <br /> removal of two 10,000-gallon USTs and one 8,000-gallon single-walled UST, dispensers, <br /> and associated product dispenser piping Laboratory analysis of soil samples collected <br /> from the UST excavation reported maximum concentrations of TPHg at 31 ppm (3W), <br /> benzene at 0 27 ppm (3W), and MtBE at 80 ppm (3E) Laboratory analysis of soil samples <br /> collected from the beneath the dispensers and product piping detected maximum <br /> concentrations of TPHg at 1,600 ppm (D1) and MtBE at 1 8 ppm (D3) Additionally, <br /> approximately 15,000 gallons of water V&"-removed from the excavation during the <br /> • installation of the new USTs Laboratory analysis of a grab groundwater sample reported <br /> maximum concentrations of TPHg, benzene, and MtBE at 17,000 micrograms per liter <br /> (µg/Q, 1,500 gg/L, and 120,000 µg/L, respectively Groundwater Monitoring Well MW-1 <br /> was destroyed to allow the enlargement of the existing UST excavation to allow for the <br /> installation of the new USTs (GR, 1999) <br /> On October 7 and 8, 1999, Cambria Environmental Technology, Incorporated (Cambria) <br /> conducted Cone Penetration Testing (CPT) by advancing six borings (CB-1 through C13-6) <br /> for soil and groundwater sampling and two borings (CB-2E and C13-4E) for electric soil <br /> logging Soil samples were collected every five feet to approxir #ely 20 feet bgs Water <br /> samples were collected using a hydropunch at depths of 16 and feet bgs in borings CB- <br /> 1, CB-2, and CB-4 through CB-6 Water samples were collected at depths of 16 and 29 <br /> feet bgs in boring CB-3 Laboratory analysis of soil samples collected from the soil borings <br /> detected maximum concentrations of gasoline range organics (GRO) at 27 milligrams per <br /> kilogram (mg/kg) (CB-3-13 5), MtBE at 21�ng/kg (CB-3-13 5), and tert amyl methyl ether <br /> (TAME) at 0 058 mg/kg (CB-3-13 5) Benzene, toluene, ethylbenzene and total xylenes <br /> (BTEX) were not detected above laboratory detection limits Laboratory analysis of <br /> groundwater samples collected from the sod borings detected maximum concentrations of <br /> GRO at 87,000 pg/L (CB-4-16HP), benzene at 1,300 µg/L (CB-4-16HP), MtBE at 38,000 <br /> µg/L (CB-1-16HP), and TAME at 160 pg/L (CB-1-16HP) (Cambria, 1999) <br /> Also in late 1999, Cambria conducted a sensitive receptor survey Based on a review of <br /> United States Geological Survey (USGS) topographic maps and recent area maps, an <br /> unnamed levy-restricted slough was identified 2,000 feet south of the site, and a man- <br /> made lake was located in a residential area approximately 1,500 feet southwest of the site <br /> Well logs obtained through the State of California, Department of Water Resources (DWR) <br /> CPT Report 9-04 doc <br />