Laserfiche WebLink
A A <br /> • <br /> ATTACHMENT A <br /> FIELD AND LABORATORY PROCEDURES <br /> Sampling Procedures <br /> The sampling procedure for each well consists first of measuring the water level and checking for the presence <br /> of separate-phase hydrocarbons (SPH), using either an electronic indicator and a clear Teflon@ bailer or an oil- <br /> water interface probe Wells not containing SPH that do not have submerged screens are then sampled without <br /> purging Wells that have submerged screens are purged of approximately three casing volumes of water(or to <br /> dryness) using a centrifugal pump, gas displacement pump, or bailer Equipment and purging method used for <br /> the current sampling event is noted on the attached field data sheets During purging, temperature, pH, and <br /> electrical conductivity are monitored in order to document that these parameters are stable prior to collecting <br /> samples After purging,water levels are allowed to partially recover Groundwater samples(both purge and no <br /> • purge) are collected using a Teflon bailer, placed into appropriate EPA-approved containers, labeled, logged <br /> onto chain-of-custody documents,and transported on ice to a California State-certified laboratory <br /> Laboratory Procedures <br /> The groundwater samples were analyzed for the presence of total petroleum hydrocarbons calculated as <br /> gasoline, benzene, toluene, ethylbenzene, xylenes, and methyl tertiary butyl ether by EPA Methods 8015 <br /> (modified), 8020, 8260A, and 5030 These analyses were performed by utilizing a purge and trap extraction <br /> technique, with final detection was by gas chromatography using flame- and photo-lomzation detectors The <br /> methods of analysis for the groundwater samples are documented in the certified analytical report The certified <br /> analytical report,chain-of-custody documentation,and field data sheets are presented as Attachment B <br /> Purge and Rinsate Water Disposal <br /> Water generated during well sampling and equipment cleaning is pumped into a SECOR truck mounted water <br /> tank The water is transported to ARCO's holding facility in West Sacramento, California, for temporary <br /> storage Water is then transported by Integrated Waste Management (IWM) to Seaport Environmental in <br /> Redwood City,California for disposal <br />