Laserfiche WebLink
For sampling chlorinated drinking water supplies for chlorinated volatiles, samples shall <br /> be preserved with sodium thiosulfate Use vials labeled 'CONTAINS THIOSULFATE " <br /> No particular cautions are necessary <br /> 7 Fill vial to overflowing with water, avoiding turbulence and bubbling as much as <br /> possible Water should stand above lip of vial <br /> 8 Carefully, but quickly, slip cap onto vial Avoid dropping the Teflon septum from cap <br /> by not inverting cap until it is in contact with the vial Disc should have Teflone face <br /> toward the water Also avoid touching white Teflon face with dirty fingers <br /> 9 Tighten cap securely, invert vial, and tap against hand to see there are not bubbles <br /> inside <br /> i <br /> 10 Label vial, using indelible ink, as follows <br /> A Sample I D No <br /> S Job I D No <br /> C Date and Time <br /> D Type of analysis required <br /> E Your name <br /> 11 Unless the fabric-type label is used, place Scotch" tape over the label to preserve its <br /> integrity <br /> 12 For chain-of-custody reasons, sample vial should be wrapped end-for-end with Scotch" <br /> tape or evidence tape and signed with indelible ink where the end of the tape seals on <br /> itself The septum needs to be covered <br /> 13 Chill samples immediately Samples to be stored should be kept at 4' Celsius (C) <br /> (39 2' Fahrenheit IF]) Samples received at the laboratory above 10'C (as measured at <br /> glass surface by a thermocouple probe), after overnight shipping, will be considered <br /> substandard, so use a high quality cooler with sufficient ice or freezer packs <br /> 14 Fill out Cham-of-Custody Manifest and Analysis Request Form (see Chain of Custody <br /> Procedures, SOP 11) <br /> CONCOHO SOP 42/941 Ppe 2 of 2 <br /> Did GROUNDWATER <br /> d_!' j TECHNOLOCY, INC <br />