ARCHIVED REPORTS_XR0004182 - Laserfiche WebLink

Home Browse Search

Equipment Cleaning Before the sampling event was started, un ment that was used to � sample groundwater P p was disassembled and cleaned with detergent water and then rinsed with demonized water During field sampling, equipment surfaces that were placed in the well or came into contact with groundwater during field sampling were steam cleaned with demonized water before the next well was purged or sampled Water Level, Floating Hydrocarbon, and Total Well Depth Measurements Before purging and sampling occurred, the depth to water, floating hydrocarbon thickness, and total well depth were measured using an od/water interface measuring system The oil/water interface measuring system consists of a probe that emits a continuous audible tone when immersed in a nonconductive fluid, such as oil or gasoline, and an intermittent tone when immersed in a conductive fluid, such as water The floating hydrocarbon thickness and water level were measured by lowering the probe into the well Liquid levels were recorded relative to the tone errutted at the groundwater surface The sonic probe was decontaminated by being rinsed with demonized water or steam cleaned after each use. A bottom-filling, clear Teflon bailer was used to verify floating hydrocarbon thickness measurements of less than 0 02 foot Alternatively, an electric sounder and a bottom-filling Teflon bailer may have been used to record floating hydrocarbon thickness and depth to water The electric sounder is a transistorized instrument that uses a reel-mounted, two- conductor, coaxial cable that connects the control panel to the sensor Cable markings are stamped at 1-foot intervals The water level was measured by lowering the sensor into the monitoring well A low-current circuit was completed when the sensor contacted the water, which served as an electrolyte The current was amplified and fed into an indicator light and audible buzzer, signaling when water had been contacted A sensitivity control compensated for highly saline or conductive water The electric sounder was decontaminated by being rinsed with deionlzed water after each use The bailer was lowered to a point dust below the liquid level, retrieved, and observed for floating hydrocarbon Liquid measurements were recorded to the nearest 0 01 foot on the Depth to Water/Floating Product Survey Form The groundwater elevation at each monitoring well was calculated by subtracting the measured depth to water from the surveyed elevation of the top of the well casing. (Every attempt was made to measure depth to water for all wells on the same day ) Total well depth was then measured by lowering the sensor to the bottom of the well Total well depth, used to calculate purge volumes and to determine whether the well screen was partially obstructed by silt, was recorded to the nearest 0 1 foot on the Depth to Water/Floatmg Product Survey Form SA(\NTJM05�NO514402CS-4Spas I A-2 Rev 0,11/21/95