Laserfiche WebLink
Site Preparation and InstE ,ion Instructions <br /> TLS-350 UST Monitoring System <br /> SECTION 4. TLS-350 MONITOR B. GENERAL WIRING PRACTICES. <br /> INSTALLATION Wiring the TLS-350 is not complicated; however, it is <br /> essential for your safety and for proper operation of the <br /> A.MOUNTING. system that you observe all warning statements and care- <br /> El Locate and mark mounting points at the location se- fully follow the instructions in this manual. <br /> lected in Section 3.0 (refer to Figure 8, "Monitor Di- Here are a few general guidelines to help insure a success- <br /> mensions and Mounting Requirements"). ful installation. <br /> BE SURE TO CONSIDER THE WEIGHT OF THE 1. Be sure all wires entering the TLS-350 monitor are <br /> CONSOLE AND THE MOUNTING SURFACE MA- color coded or marked to identify their source. <br /> TERIAL WHEN SELECTING A MOUNTING FAS- <br /> TENER. 2. Each module comes with a terminal connector.Do not <br /> remove the connector from the module during <br /> If the fastening device requires an insert in the mount- wiring. <br /> ing surface,drill the appropriate holes and install the <br /> inserts.Up to 1/4"screws or bolts may be used. Terminal identifications appear only on the module <br /> bracket. Removing the connector for wiring increases <br /> Mount the monitor to the mounting surface through the risk of connecting wires to the wrong terminals. <br /> the holes in the four mounting flanges located on the <br /> top and bottom of the monitor. 3. Label all connectors according to the number of the slot <br /> in which their modules are installed. A sheet of <br /> Connect the power wiring conduit and probe and sen- self-adhesive number labels is supplied with each sys- <br /> sor wiring conduit(s)in the appropriate knockouts. tem and with each module. <br /> 4. Record all required wiring information on the circuit <br /> directory located on the back of the right-hand door. <br /> (See Figure 10,"Circuit Directory-Example.") <br /> 14 <br />