Laserfiche WebLink
Connecting the Wiring Line Leak Sensor Field Wiring Connections <br /> CAUTION: Epoxy sealant may be irritating to skin and eyes, absorbed <br /> through the skin, or cause skin sensitization in susceptible individuals. Minor <br /> injury may result. Also materials contained in epoxy have caused skin cancer <br /> in animal tests. <br /> CAUTION: Avoid skin and eye contact. Wear appropriate safety equipment. <br /> Use only in well ventilated areas. <br /> 3. Seal wire nut connections using the epoxy sealant furnished with each PLLD.Use <br /> one packet for no more than two wire nut connections. Ensure the end of the <br /> cable jacket is covered by the epoxy. <br /> 4. Seal wire nut connections using the epoxy sealant furnished with each PLLD.Use <br /> one packet for no more than two wire nut connections.Refer to Figure 16 as you <br /> prepare epoxy and seal connections. <br /> Using thumbs and forefingers as <br /> i shown,bend epoxy sealant package <br /> back and forth until seal between <br /> compound sections has broken. <br /> Then using fingers squeeze <br /> package to mix sealant. <br /> i <br /> When mixture becomes well <br /> blended and warm, cut off one end <br /> of package and insert the wire nuts <br /> and wires down into the sealant <br /> mixture. Use tie wrap to close up <br /> package around wires. <br /> To sensor To console <br /> Make sure that end of Tie wrap <br /> cable jacket is <br /> submerged in sealant. <br /> / Wire nuts <br /> Cb <br /> 'Sa��ro <br /> Figure 16. Epoxy Sealant Connections <br /> 576013-902,Revision G 35 <br />