INSTALL_1985 - Laserfiche WebLink

Home Browse Search

Step 11 Install OPW 61-T DROP TUBE,OPW TIGHT FILL ADAPTOR,and OPW TIGHT FILL CAP. WATER LEAKAGE TEST • Fill unit to final grade level with water. • Any drop in test water level within one hour is unacceptable. • In case of water level drop,refer to steps 9 and 10 to check for proper installation of SECOND SEAL (H-6528-M)and proper torque of CLAMP SCREW. • Push down on DRAIN VALVE BUTTON several times to check for proper operation and to flush any foreign materials. • REPEAT TEST. Step 12 Replace SPILL CONTAINER COVER and securely fasten COVER PROTECTIVE DISC(tape may be used). This DISC has been supplied to prevent wet concrete or other foreign materials from contacting COVER, HANDLE,or O-RING SEAL.Make sure CONCRETE FORM is in place and firmly supported during pouring of concrete. Step 13 After concrete has been poured and properly set, Carefully remove DISC and COVER.Clean COVER O-RING,GROOVE,BODY RING RECESS and BOTTOM OF CONTAINER.Replace COVER and discard PROTECTIVE DISC. Thank you for reading these instructions.Thank you for carefully installing the world's best SPILL CONTAINER. Please leave these instructions and maintenance procedures with OWNER/OPERATOR of station. PREVENTIVE MAINTENANCE ORW 84-D SPILL CONTAINER The OPW 84 series is designed to require a minimum of maintenance. However,the following will be useful to obtain the optimum performance of the 84-D container. • Regularly inspect and clean the COVER SEAL and BODY RING.Remove accumulated dirt and grit. Inspect the SEAL for cuts and breaks. Replace if necessary.A missing or cut SEAL will allow surface water to enter the CONTAINER and vapor to escape. Escaping vapor can present a flammable hazard. • Clean out HANDLE RECESS periodically to allow HANDLE to move and fall freely into lid recess. • To avoid hazardous conditions,be sure HANDLE is in recessed position. • Inspect CONTAINER for cracks or cuts.CONTAINER must remain tight and not leak fuels or oil into soil. • Be sure SEAL and CLAMP are in proper position and tight. • Remove debris from around VALVE SCREEN to allow proper draining. • Be sure valve RETURN SPRING is in place and working to seal VALVE. FUELING COMPONENTS GROUP CORPORATION / OPW DIVISION 9393 PRINCETON-GLENDALE ROAD P.O.BOX 405003-CINCINNATI,OHIO 45240-5003 TELEPHONE(513)870-3219 1, ,,o Copyright 1985 Dover Corp./OPW Division Printed in U.S.A. 1