Laserfiche WebLink
Performance Primary operating pressures to 300 psi(20 bar) <br /> Continuous operating temperature to 150°F(66°C) <br /> Containment system pressures to 40 psi(2.9 bar) <br /> Individual system components may not have the same ratings as the pipe.Refer to the <br /> detailed product information for the specific components to determine the pressure rating <br /> for the system as a whole. <br /> Composition Primary pipe:Filament-wound fiberglass reinforced epoxy pipe with integral epoxy liner <br /> and exterior coating.When classified in accordance with ASTM D2310 and ASTM <br /> D2996,the pipe meets the following cell limits:RTRP 11 CX-5430. <br /> Pipe containment:Filament-wound fiberglass reinforced epoxy pipe. <br /> Interstitial space:Dry sand particles(10-20 mesh)secured in place with adhesive <br /> backed tape. <br /> Fittings:Compression molded or filament-wound fiberglass reinforced epoxy primary <br /> fittings.Containment fittings are molded. <br /> Adhesive:Ameron B20,PSX"920 or PSX-934 ambient-cure,two-part epoxy for all services <br /> (including alcohols and MTBE). <br /> Joining system Primary:Bell and spigot taper/taper adhesive-bonded joint <br /> Containment:Adhesive-bonded clamshell fittings.Parts are compression molded for <br /> exact fit and match.Material is identical to primary fittings and is fully Listed by U.L.for all <br /> services,including use in MTBE fluids. <br /> Pipe lengths Standard 20 ft.(6.1 m)random lengths 17 to 21 ft.(5.2 to 6.4 m) <br /> and 27 ft.(8.2 m)random lengths 25 to 27 ft.(7.6 to 8.2 m) <br /> Other lengths up to 42 ft.available upon request. <br /> Fittings Primary- Adapters:bell x NPT male' Flange stub ends' <br /> Adapters:bell x NPTfemale2 Isolation bushings' <br /> Adapters:spigot x NPT female2 Nipples2 <br /> Adapters:spigot x NPT male2 Reducer bushings',2 <br /> 45°elbows' Repair couplings' <br /> 90°elbows' Sleeve couplings2 <br /> End caps' Tees' <br /> Flange rings' Dispenser pan penetration fittings' <br /> Containment- 45°elbows' Couplings' <br /> 90°elbows' Tees' <br /> Termination sleeves',3 <br /> 1 Molded fitting <br /> 2 Filament-wound fitting <br /> 3 2-inch available with or without test valve.3-and 4-inch available only with test valve <br /> 2 <br />