Laserfiche WebLink
SAN ) O A Q U I N Environmental Health Department <br /> COUNTY <br /> 5. All ice machines and bins, food preparation sinks, warewashing sinks (dishwashing units), <br /> display cases and refrigeration units, and any other food service equipment which discharges <br /> liquid waste, shall be drained by means of indirect waste pipes discharged through an air gap <br /> into a floor sink or other approved waste receptor. All floor sinks are to be positioned to be <br /> readily cleanable, accessible for inspections, and must be flush with finished floor. Do not <br /> place floor sinks inside walk in refrigeration units or cabinets [CRFC §114193 and §114193.1]. <br /> 6. Install grease traps/interceptors as directed by local building codes. A grease trap or <br /> interceptor shall not be located in a food or utensil handling area [CRFC §114201]. <br /> 7. Hot water shall be supplied at a minimum temperature of at least 120°F measured from the <br /> faucet. The water heater shall have a minimum rating of 21 KW [CRFC §1141921. <br /> 8. A completed exhaust-hood form was not submitted. The exhaust-hood form appendix found in <br /> the application packet for Retail Food Facility Plan Review must be completed. <br /> 9. A noncombustible material (stainless steel, etc.) is required directly behind all cooking <br /> equipment from the bottom of the exhaust hood canopy to the top of the floor coving on all <br /> adjacent wall surfaces, and must extend six (6) inches beyond all cooking equipment edges. <br /> The exhaust hood shall also have substantially tight fitting seams and joints (welded, soldered <br /> or brazed---caulking is not accepted) [NFPA#6, CMC Chapter 4 & 5] . <br /> 10. The exhaust hood must be constructed to meet the requirements of the California Mechanical <br /> Code [CRFC §114149.1]. <br /> The EHD must be kept informed of the construction progress. A final inspection must be performed, <br /> operating permit fees paid, and approval to operate granted prior to opening for business. All <br /> equipment must be installed and thorough cleaning completed prior to the final inspection. Inspections <br /> must be scheduled at least 48 hours in advance. Charges for additional inspections, re-inspections <br /> and/or consultations may be assessed at the EHD hourly rate of $152 per hour. <br /> Any item(s) inadvertently overlooked in the plan check process, which is not in compliance with <br /> applicable State laws, and/or city or county ordinance codes, shall be constructed or reconstructed <br /> upon request of the EHD. Inferior workmanship, equipment, or materials will not be accepted for the <br /> construction or operation of a food facility. Any variance from the requirements outlined in this letter <br /> will require written approval from the EHD. Approval of the submitted plans shall become null and void <br /> if the work authorized is not commenced within 180 days from the date of approval, or the work <br /> authorized by such plans is abandoned. In order to renew action on an expired plan approval, the <br /> applicant shall submit fees equal to that of a new plan review. A copy of the approved plans shall be <br /> available on site at the time of final inspection. <br /> If you have any questions, please contact, Kadeanne Linhares Senior Registered Environmental <br /> Health Specialist, at (209) 468-0330. <br /> Sincerely, <br /> 2 of 4 <br />