Laserfiche WebLink
1 <br /> s <br /> 190569 1R ITE NV P START <br /> Section 9. Exposure controls/personal protection <br /> Control parameters 3 <br /> _calpational.exraosure lirnifs <br /> None. 1 <br /> i <br /> Appropriate engineering : Good general ventilation should be sufficient to control worker exposure to airborne l <br /> controls contaminants. i <br /> Environmental exposure Emissions from ventilation or work process equipment should be checked to ensure <br /> controls they comply with the requirements of environmental protection legislation. In some <br /> cases, fume scrubbers,filters or engineering modifications to the process equipment 1 <br /> will be necessary to reduce emissions to acceptable levels. <br /> 1 <br /> Individual protection measures <br /> Hygiene measures Wash hands, forearms and face thoroughly after handling chemical products, before <br /> eating, smoking and using the lavatory and at the end of the working period. <br /> Appropriate techniques should be used to remove potentially contaminated clothing. <br /> Wash contaminated clothing before rousing. Ensure that eyewash stations and safety t <br /> showers are close to the workstation location. <br /> Eyofface protection Safety eyewear complying with an approved standard should be used when a risk <br /> assessment indicates this is necessary to avoid exposure to liquid splashes, mists, <br /> gases or dusts. If contact Is possible,the following protection should be worn, unless <br /> the assessment indicates a higher degree of protection; safety glasses with side- <br /> shields. <br /> Skin protection <br /> Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be <br /> worn at all times when handling chemical products if a risk assessment indicates this is <br /> necessary. <br /> Body protection Personal protective equipment for the body should be selected based on the task being <br /> performed and the risks involved and should be approved by a specialist before <br /> handling this product. <br /> Other skin protection ; Appropriate footwear and any additional skin protection measures should be selected <br /> I <br /> based on the task being performed and the risks involved and should be approved by a <br /> specialist before handling this product. <br /> Respiratory protection : Use a properly fitted, air-purifying or air-fed respirator complying with an approved <br /> standard if a risk assessment indicates this is necessary. Respirator selection must be <br /> based on known or anticipated exposure levels, the hazards of the product and the safe E <br /> working limits of the selected respirator. 3 <br /> E <br /> [[ectlon 9. Physical and chemical properties <br /> Appearance r <br /> Physical state Liquid, <br /> i <br /> Calor Clear water white 1 <br /> Odor None, <br /> Odor threshold Not available, <br /> i <br /> PH 2,4 <br /> Melting point 0°C(32°F) <br /> Boiling point : '100°C (212°I") <br /> Flash point Not available. <br /> { <br /> Evaporation rate Not available. <br /> Flammabili# solid <br /> y (solid, Not available, � <br /> Lower and upper explosive Not available, <br /> (flammable) limits <br /> Vapor pressure Not available. <br /> Vapor density Not available, <br /> Data of fasuc/Oate of rovislnn :i/1b/2015. 4/R <br />