Laserfiche WebLink
3 <br /> I <br /> IRIDITE NCP,5TARX f <br /> ection 8. Exposure controls/personal pl<etecfl®n <br /> Confrol}�ararne4ers - �� <br /> Qccupationa€ax��astrr•e lirtr€ts � I <br /> Nona. t <br /> r <br /> i <br /> Appropriate engineering Good general ventilation should be sufficient to control worker exposure to airborne t t <br /> Controls contaminants. i <br /> Environmental exposure Emissions from ventilation or work process equipment should be checked to ensure <br /> controls they comply with the requirements of environmental protection legislation, In some ; <br /> cases, fume scrubbers,filters or engineering modifications to the process equipment <br /> will be necessary to reduce emissions to acceptable levels. <br /> individual rot ett n moasures g <br /> Hygiene measures : Wash hands, forearms and face thoroughly after handling chemical products, before <br /> eating,smoking and using the lavatory and at the and of the working period, <br /> Appropriate techniques should be used to remove potentially contaminated clothing. <br /> Wash contaminated clothing before reusing. Ensure that eyewash stations and safety <br /> showers are close to the workstation location. € <br /> Eyelface protection Safety eyewear complying with an approved standard should be used when a risk <br /> assessment indicates this is necessary to avoid exposure to liquid splashes, mists, <br /> gases or dusts. If contact is possible, the following protection should be worn, unless t ! <br /> tine assessment indicates a higher degree of protection: safety glasses with side- s <br /> shields, <br /> Skin nratec on i <br /> Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be <br /> worn at all times when handling chemical products if a rlslc assessment indicates this Is <br /> necessary, } <br /> Body protection Personal protective equipment for the body should be selected based on the lash being <br /> performed and the risks involved and should be approved by a speciallst before <br /> handling this product, <br /> Other skin protection : Appropriate footwear and any additional skin protection measures should be selected <br /> based on the task being performed and the risks involved and should be approved by a <br /> specialist before handling this product. 3 <br /> Respiratory protection Use a properly fitted, alr,purifying or air-fed respirator complying with an approved <br /> standard if a risk assessment indicates this Is necessary. Respirator selection must be <br /> based all known or anticipated exposure levels, the hazards of the product and the safe <br /> working Ilmits of the selected respirator. <br /> Section 9. Physical and ehelinical prepertiles <br /> Appearance <br /> Physical state Liquid. <br /> Color Clear water white <br /> i <br /> Odor Nene. <br /> Odor threshold Not available, j f <br /> PH 2,d i <br /> Molting point 0°C(32T) <br /> Bolling point 100°C(212°t=) <br /> Plash paint .....Not available, <br /> .............. .............1.... ................... - ................................................. ................... . ..................- <br /> Evaporation rate Not available, ? <br /> Flammability(Solid, gas) : Not available, <br /> Lower and upper explosive Not available. � <br /> (flarnrnablo)limits <br /> t ; <br /> Vapor pressure Not available. <br /> Vapor density : Not available, <br /> r <br /> Data of issue/Oafs of ravI.alnn 05/207.5- 4181 ; <br /> t 9 <br />