COMPLIANCE INFO_COMPLIANCE INFO 1983-2007

Home Browse Search

P-C-111C TABLE H. Comparison formula Percent by Volume Components Type II/ Type II Ethylene glycol monobutyl ether, conforming to TT-E-776 15.4 7.7 Diethylene glycol diethyl ether (sp. gr. 0.906-0.911 at 20/20°C. boiling range 180°-190°C. at .760 mm. acidity not over 0.02 percent as acetic acid) 13.4 6.7 Diethylene glycol monobutyl ether (sp. gr. 0.953-0.958 at 20/20°C. ; boiling range 220°-235°C. at 760 mm. acidity not over 0.02 percent as acetic acid) 7.8 3.9 Diethylene glycol monomethyl ether (sp. gr. 1 .025-1 .031 at 20/20°C. ; boiling range 188°-198°C. at 760 mm. ; acidity not over 0.02 percent as acetic acid) 4.0 2.0 Detergent, nonionic conforming to MIL-D-16791 , type 1 3.6 1 .8 Oleic acid, technical 4.0 2.0 Monoethanolamine (sp. gr. 1 .017-1 .027 at 20/200C. ; boiling range 1600-1760C. at 760 mm.) 40.6 20.3 Sodium silicate solution (0.25 percent by volume of /1 40° Baume solution?/ in distilled water) -- 55.6 �V� Sodium silicate solution (2.48 percent by volume of \�I 40° Baume solution/ in distilled water) 11 .2 -- h� I 2/Sodiumthe silicate, 40' Baume, with ith aequal volume distilled water. witha ratio of1 Na20:3.2Si02hasproved Q — satisfactory. 4.5. 19.3 Preparation of piston for testing. Aluminum pistons taken from internal combustion engines shall be cleaned with hard bristle brush and mineral spirits or Stoddard solvent. Dry them with paper towelling. Select six pistons which have at least three-fourths of the surface covered with heavy crusty soil . Cut each piston into 12 equal sections, leaving an uncut center section approximately 1/2 to 3/4 inch in diameter (see fig. 2) . From each piston select not less than 4 pair of matched adjacent sections; that is sections which are soiled as similarly as possible. Pistons larger than 4-1/2 inches in diameter may be cut into 16 sections . 18