Laserfiche WebLink
MIIrG11796B <br /> JAN-H-792 —Humidity Cabinet; AMERICAN SOCIETY FOR TESTING <br /> Operation of. MATERIALS PUBLICATIONS <br /> 3EL-L-6082 —Lubricating Oil; Air- ASTM Standard on Petroleum Products <br /> craft Reciprocating and Lubricants. <br /> (Piston) Engine. <br /> STANDARDS ASTM Manual on Measurement and <br /> Sampling of Petroleum and Petroleum <br /> FsDERAL Products. <br /> Federal Test —Paint, Varnish, Lac- (Copies of ASTM publications may be obtained <br /> Method quer, and Related from the American Society for Testing Materials, <br /> Standard Materials; Methods 1916 Race Street, Philadelphia 3, Pa.). <br /> No. 141 of Inspection, Sam- <br /> pling,and Testing. 3. REQUIREMENTS <br /> Federal Test —Lubricants, Liquid <br /> Method Fuels, and Related 3.1 Qualification. The corrosion preventive <br /> Standard Products; Methods compound furnished under this specification <br /> No. 791 of Testing. shall be a product which has been tested and <br /> MILITARY passed the qualification tests specified herein <br /> (see 4.5.1 and 6.3), and has been listed on or <br /> MIL-STD-290 —Packaging, Packing, approved for listing on the applicable quali- <br /> and Marking of fied products list. <br /> Petroleum and Re- i <br /> lated Products. 3.2 Material. The corrosion preventive <br /> (Copies of specifications,standards,drawings,and compound shall be a petrolatum which has J <br /> other publications required by contractors in con- been modified to meet the specified require- <br /> nection with specific procurement functions should ments. The material shall be free from grit, <br /> be obtained from the procuring agency or as di- water, and other impurities, and shall not be <br /> rected by the contracting officer). <br /> injurious in any way to personnel in its in- <br /> 2.2 Other publications.The following docu- tended use. <br /> ments form a part of this specification to the <br /> extent specified herein. Unless otherwise in- 3.3 Physical requirements. The corrosion <br /> dicated, the issue in effect on date of invi- preventive compound shall conform to the <br /> tion for bids shall apply. following physical requirements (see 4.6.1). <br /> Clap 1 or 1A Clap t Clap! <br /> Penetration, tenths of mm. .............. 30-80 90-150 200-325 <br /> Flash point, ° F., minimum .............. 350 350 350 <br /> Melting point, ° F., minimum .......... 155 150 135 <br /> 3.4 Sulfated residue. The sulfated residue or higher, the sulfated residue of any suc- 1 <br /> of each product will be established when ceeding lot shall be ±15 percent of the <br /> qualification tests are conducted. When the es- established value (see 4.6.1). The deviations <br /> tablished value of the accepted sample is 0 to permitted herein are manufacturing toler- <br /> 0.50 per cent, the sulfated residue of any suc- <br /> ceeding lot shall be ±0.05 (absolute value) antes and are separate from those indicated <br /> with a zero minimum. When the established in 4.6.1. The latter deviations reflect the ac- <br /> value of the accepted sample is 0.51 percent curacy of the method (see 4.6.1 and 6.4) <br /> �i <br /> 2 <br /> - y <br />