ARCHIVED REPORTS_XR0004530 - Laserfiche WebLink

Home Browse Search

i k Lancaster Laboratories Abbreviations k 2425NewHollandPike•Lancaster,PAI'e Explanation of Symbols and The following defines common symbols and abbreviations used in reporting technical data: N.D. none detected BMQL Below Minimum Quantitation Level TNTC Too Numerous To Count MPN Most Probable Number IU International Units CP Units cobalt-chloroplatinate units umhoslcm micromhoslcm NTU nephelometric turbidity units C degrees Celsius F degrees Fahrenheit .. meq milliequivalents lb. pound(s) j g gram(s) kg kilogram($) ug microgram(s) mg milligram(s) MI milliliter(s) I liter(s) m3 cubic meter(s) ul microliter(s) I: < less than-The number following the sign is the limit of quantitation, the smallest amount of analyte which can be reliably determined using this specific test. > greater than 3 estimated value—The result is>_the Method Detection Limit(MDL) and <the Limit of Quantitation (LOQ). ppm parts per million -One ppm is equivalent to one milligram per kilogram (mg/kg), or one gram per million grams. For aqueous liquids, ppm is usually taken to be equivalent to milligrams per liter(mg/1), because one liter of water has a weight very close to a kilogram. For gases or vapors, one ppm is equivalent to one microliter of gas per liter of gas. ppb parts per billion Dry weight Results printed under this heading have been adjusted for moisture content. This increases the analyte weight basis concentration to approximate the value present in a similar sample without moisture. All other results are reported a on an as-received basis. U.S. EPA CLP Data Qualifiers: ,._ Organic Qualifiers Inorganic Qualifiers A TIC is a possible aldol-condensation product B Value is<CRDL, but>--IDL B Analyte was also detected in the blank E Estimated due to interference C Pesticide result confirmed by GC/MS M Duplicate injection precision not met D Compound quantitated on a diluted sample N Spike sample not within control limits E Concentration exceeds the calibration range of S Method of standard additions(MSA) used the instrument for calculation N Presumptive evidence of a compound (TICs only) U Compound was not detected P Concentration difference between primary and W Post digestion spike out of control limits confirmation columns >25% Duplicate analysis not within control limits U Compound was not detected + Correlation coefficient for MSA<0.995 X,Y,Z Defined in case narrative Analytical test results for methods listed on the laboratories' accreditation scope meet all requirements of NELAC unless otherwise noted under the individual analysis. Measurement uncertainty values, as applicable, are available upon request. ; Tests results relate only to the sample tested. Clients should be aware that a critical step in a chemical or microbiological analysis is the collection of the sample. Unless the sample analyzed is truly representative of the bulk of material involved, the test results will be meaningless. If you have questions regarding the proper techniques of collecting samples, please contact us. We cannot be held responsible for sample integrity, however, unless sampling has been performed by a member of our staff. This report shall not be reproduced except in full, without the written approval of the laboratory. WARRANTY AND LIMITS OF LIABILITY-In accepting analytical work, we warrant the accuracy of test results for the sample as submitted. THE FOREGOING EXPRESS WARRANTY IS EXCLUSIVE AND IS GIVEN IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED. WE DISCLAIM ANY OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING A WARRANTY OF FITNESS FOR PARTICULAR PURPOSE AND WARRANTY OF MERCHANTABILITY. IN NO EVENT SHALL LANCASTER LABORATORIES BE LIABLE FOR INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES INCLUDING, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF PROFIT OR GOODWILL REGARDLESS OF (A)THE NEGLIGENCE(EITHER SOLE OR CONCURRENT)OF LANCASTER LABORATORIES AND(B)WHETHER LANCASTER LABORATORIES HAS BEEN INFORMED OF THE POSSIBILITY OF SUCH DAMAGES. We accept no legal responsibility for the purposes for which the client uses the test results. No purchase order or other order �..,or work shall be accepted by Lancaster Laboratories which includes any conditions that vary from the Standard Terms and Conditions of Lancaster Laboratories and we hereby object to any conflicting terms contained in any acceptance or order submitted by client. 3768.02