SR0081792 - Laserfiche WebLink

Home Browse Search

Live Oak presaturated the percolation test hole approximately 24 hours prior to the percolation testing. The hole was filled with water to a height of 12 inches above the bottom of the boring for the presaturation. On the day of testing, the hole was found to be intact and dry. Percolation Test Procedure Live Oak conducted a four-hour percolation test for the boring on November 12, 2019. Water level measurements were taken every 30 minutes during this four-hour period. The last 30 minutes of the test were observed by Sukhreet Kaur, Registered Environmental Health Specialist at the San Joaquin County Environmental Health Department. An electronic well sounder with a depth accuracy of 1/100th foot was utilized for the water level measurements. The water level was measured against a fixed reference point on the well casing. Measurements were recorded on the data sheet in decimal feet. When necessary after measuring the water level, the hole was refilled with water to a level of six inches or more above the bottom of the hole. Percolation Test Results The completed percolation test form is included in Appendix 3 of this report. The form was signed by Ms. Kaur and indicates a percolation rate for the hole based on the least water drop observed during the test period, as required by San Joaquin County Environmental Health Department policy (personal communication with Michael Kith, Lead REHS, November 19, 2019). Per San Joaquin County Environmental Health Department's definition, a shallow percolation test hole has a depth between 36 and 42 inches; a satisfactory percolation rate for a shallow test is greater than or equal to 1 minute per inch (min/in) but less than or equal to 60 min/in drop. For the Site to utilize a standard septic system, one percolation test must demonstrate a satisfactory percolation rate within the proposed septic system disposal field. Details and results of the percolation test are summarized in the following table. LOGE 1946 Page 6