ARCHIVED REPORTS_XR0005109 - Laserfiche WebLink

Home Browse Search

2.0 GROUNDWATER MONITORING, SAMPLING AND ANALYSIS On March 22, 2005, to comply with quarterly groundwater monitoring requirements, Ramage Environmental monitored and sampled the three monitoring wells at the site 2,1 Groundwater Monitoring Upon arrival at the site, each of the wellheads was inspected, unlocked and opened Depth-to- groundwater was measured to within 0 01 feet using a water level indicator p � The static g depth to the groundwater oundwater table, as measured in the three groundwater monitoring wells, ranged from 19 35 feet bgs in MW-2 to 19 51 feet bgs in MW-1 The corresponding groundwater surface elevation ranged from a high of 17 30 feet above mean sea leve! (msi) at MW-2 to a low of 17 15 feet above msl at MW-1 The resulting groundwater surface appears as a regular plane dipping to the northwest at a gradient of approximately 0 0025 foot/foot A groundwater surface contour map is included as Figure 3 The well construction details, wellhead elevations and groundwater monitoring data are summarized in Table 1 22 Groundwater Sampling and Analysis Following groundwater level measurements, all three wells were purged and sampled The wells were purged using a pump and dedicated disposable tubing, until at least three well casing volumes were extracted and/or after groundwater temperature, pH and electrical conductivity values had stabilized The sampling information field sheets are included in Appendix A Following well purging and recharge, groundwater was sampled from the wells using dedicated disposable bailers and laboratory-supplied containers The groundwater samples were transported in an iced cooler with chain-of-custody documentation to Excelchem Environmental Labs (Excelchem), a state of California certified hazardous waste testing laboratory (Certification #2119) Excelchem analyzed each of the groundwater samples for TPH-as-diesel, TPH-as- gasoline, benzene, toluene, ethylbenzene, and xylenes (BTEX) by EPA Method 8020/8015M, and for methyl tertiary butyl ether (MTBE), di-isopropyl ether (DIPS), ethyl tertiary butyl ether(ETBE), tertiary amyl methyl ether(TAME) and tertiary butanol (TBA) and 1,2-DCA by EPA Method 8260B 7