ARCHIVED REPORTS_XR0006016 - Laserfiche WebLink

Home Browse Search

CAM BRIA STANDARD FIELD PROCEDURES FOR GROUNDWATER MONITORING AND SAMPLING This document presents standard field methods for groundwater monitoring, purging and sampling, and well development These procedures are designed to comply with Federal, State and local regulatory guidelines Cambria's specific field procedures are summarized below Groundwater Monitoring Prior to performing monitoring activities, the historical monitoring and analytical data of each monitoring well shall be reviewed to determine if any of the wells are likely to contain separate phase hydrocarbons (SPH) and to determine the order in which the wells will be monitored (i a cleanest to dirtiest) Groundwater monitoring should not be performed when the potential exists for surface water to enter the well (i e flooding during a rainstorm) Prior to monitoring, each well shall be opened and the well cap removed to allow water levels to stabilize and equilibrate The condition of the well box and well cap shall be observed and recommended repairs noted Any surface water that may have entered and flooded the well box should be evacuated prior to removing the well cap In wells with no history of SPH,the static water level and total well depth shall be measured to the nearest 0 01 foot with an electronic water level meter Wells with the highest contaminant concentrations shall be monitored last In wells with a history of SPH, the SPH level/thickness and static water level shall be measured to the nearest 0 01 foot using an electronic interface probe The water level meter and/or interface probe shall be thoroughly cleaned and decontaminated at the beginning of the monitoring event and between each well Monitoring equipment shall be washed using soapy water consisting of Liqui-noxTM or AlconoxTm followed by one rinse of clean tap water and then two rinses of distilled water Groundwater Purging and Sampling Prior to groundwater purging and sampling, the historical analytical data of each monitoring well shall be reviewed to determine the order in which the wells should be purged and sampled (i e cleanest to dirtiest) No purging or groundwater sampling shall be performed on wells with a measurable thickness of SPH or floating SPH globules If a sheen is observed, the well should be purged and a groundwater sample collected only if no SPH is present Wells shall be purged either by hand using a disposal or PVC bailer or by using an aboveground pump (e g peristaltic or WatteraTm) or down-hole pump (e g GrundfosTm or DC Purger pump) Groundwater wells shall be purged approximately three to ten well-casing volumes (depending on the regulatory agency requirements) or until groundwater parameters of temperature, pH, and conductivity have stabilized to within 10% for three consecutive readings Temperature, pH, and conductivity shall be measured and recorded at the start of purging, once per well casing volume removed, and at the completion of purging The total volume of groundwater removed shall be recorded along with any other notable physical characteristic such as color and odor If required, field parameters such as turbidity, dissolved oxygen (DO), and oxidation-reduction potential (ORP) shall be measured prior to collection of each groundwater sample Groundwater samples shall be collected after the well has been purged and allowed to recharge to $0% of the pre-purging static water level, or if the well is slow to recharge, after waiting a minimum of 2 hours Groundwater samples shall be collected using clean disposable bailers or • pumps (if an operating remediation system exists on site and the project manager approves of its use for sampling) and shall be decanted into clean containers supplied by the analytical laboratory New latex gloves and disposable tubing or bailers shall be used for sampling each well If a PVC bailer or down-hole pump is used for groundwater purging, it shall be Page i of 2