Laserfiche WebLink
(`ORG CGLOSS.ARYOF D,AT.-kQUALIFIERS_XQ kBBREN"IATIONS <br /> Inorganic Data Oualifiers <br /> B Result is less than the CRDL. but greater than or equal to the IDL <br /> E Result is estimated because of the presence of interference <br /> yi The RSD of duplicate injections exceeded 20% for analyte concentrations greater than the CRDL <br /> V. Matrix Spike recovery was outside the control limits <br /> S Result was determined by the Method of Standard Additions (MSA) <br /> T Analyte was found in the associated TCLP extraction blank and sample <br /> U Analyte was analyzed for but not detected at or above the IDL (for CLP analysis), or at or above the <br /> reporting limit for non-CLP analysis <br /> W Post-digestion spike was outside the control limits (85-1150, and the sample absorbance is less than <br /> 50% of the spike absorbance <br /> + The correlation coefficient for the MSA is less than 0.995 <br /> ' Duplicate analysis (or QC result) was outside the control limits - <br /> Method Ouallffers <br /> A Analyzed by flame A.A.direct aspiration <br /> C Analyzed by manual spectrophotometric method for Cyanide , F, <br /> CV Analyzed by manual cold vapor generation A.A. for Mercury <br /> F Analyzed by graphite furnace atomic absorption spectroscopy <br /> P Analyzed by inductively coupled argon plasma <br /> Abbreviations <br /> BS Blank Spike: spike analysis was conducted on reagent grade water or a matrix free from the analyte(s) <br /> of interest. <br /> BSD Blank Spike Duplicate <br /> BRL Below Reporting Limit " <br /> CCV Continuing Calibration Verification <br /> _o t <br /> CCB Continuing Calibration Blank <br /> CD Calculation Factor used by the Laboratory's Information Management System (LIMS) <br /> DF Dilution Factor <br /> ICV Initial Calibration Verification _ <br /> 1CB Initial Calibration Blank w " <br /> LCS or (LC) denotes Laboratory Control Standard <br /> MB Method Blank or (PB) for Preparation Blank <br /> MS Matrix Spike <br /> MSD Matrix Spike Duplicate <br /> NA Not Applicable <br /> NC Not calculated <br /> NR Not Required <br /> NS Not Spiked <br /> REP Replicate analysis <br /> RFW# Equivalent to the laboratory sample identification (LAB ID) <br /> RPD Relative Percent Difference of duplicate analyses <br /> X Laboratory-defined qualifier: description included in the narrative <br /> NOTES: <br /> • One or a combination of these data qualifiers and abbreviations may appear in the analyncal report. <br /> I <br /> • Soil, sediment and sludge results are reported on a dry weight basis except when analyzed for landfdl disposal or incineration <br /> parameters. All other results on a solid matrix are reported on an -as received" basis unless noted differently. <br /> • Reporting limits are adjusted for preparation sample size,sample dilutions, and sample moisture content if analyzed on a dry <br /> weight basis. <br /> Revised 0'.'01,194 n <br /> "f' A <br />