ARCHIVED REPORTS_XR0005947 - Laserfiche WebLink

Home Browse Search

' k'q KLFINFELDER 2 Approximately one week to one month prior to conducting the sampling, the residual pressures at the air-Iine of each lysimeter are measured and the vacuum reset to ' manufactured recommended value (usually 50 centibars) The measurements and applied vacuums are noted on a sampling log form Kleinfelder has found that resetting the lysimeters vacuums before the sampling yields good sample recovery ' 3 The residual pressures are measured dust prior to collecting the sample The water line is then opened and nitrogen gas applied to the air line until either fluid or air is discharged 1 (for dry lysimeters) The sample is contained in a 1 liter unpreserved bottle and the volume recovered is estimated The fluid is then poured into appropriate preserved or unpreserved bottles of the requested analysis 4 After the sample is collected, the lysimeter vacuum is reset to the manufacturer's recommended value The lysimeter is also tested to evaluate potential leaks that may ' cause vacuum pressure loss ' A-6 Leachate Monitoring I The leachate riser or wells are first opened and allowed to equilibrate with the atmosphere 2 The leachate elevation is then measured from a set location using a conductivity-based water-level meter The level is generally measured from a surveyed mark on the north rim of the casing ' 3 A leachate sample is then collected using a clean, disposable bailer ' 4 The sample is labeled and immediately stored in an iced cooler pending transport to the analytical laboratory The sample is logged on a chain-of-custody A-7 Surface Water Monitoring ' 1 Prior to collecting surface water samples, the depth of water is estimated at a designated location in the surface water body I 2 Surface water samples are collected directly from the stream or surface water using a clean unpreserved plastic bottle, disposable bailer, bailer, coliwasa, DipstikTM, dipper, peristaltic pump, etc , or by directly filling the sample containers Sampling equipment ' will either be disposable, dedicated or decontaminated in accordance with the above- defined decontamination protocols Care is taken not to disturb the stream bottom and introduce sediment in the sample The fluid is then poured into appropriate preserved or unpreserved bottles for the requested analysis 20-2322-05 E01/20118061 Page A-7 Copyright 2001,Klemfelder,Inc January 12,2001