COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

VXD Specification TYPICAL SPECIFICATIONS Model: VXD Description: Application: Fan shall be a spun aluminum and G90 Galvanized, roof or wall mounted, direct drive, upblast centrifugal exhaust ventilator. Fans up to and including models with a 24" nominal wheel and a 2 HP motor are suitable for wall mounting. Centrifugal roof exhausters are engineered to discharge grease laden vapors, fumes and other contaminants vertically away from the building. All models shall be ETL Listed and comply with 1.11:705 (electrical) Standards and CSA Std C22.2, No 113. Models 12 Certifications: thru 85 are ETL Listed and comply with LiL762 Standards. Fan shall bear the AMCA certified ratings seal for sound and air performance. Construction: Housing The fan windband shall be constructed of heavy gauge aluminum or G90 Galvanized and shall be spun on an automatic lathe to provide conelstent dimensions. Horizontal and vertical internal supports shall be used to securely fasten the windband to the diseherge apron to provide rigidity for hinging and added strength to reduce shipping damage. The discharge apron shall have a rolled bead for added strength. Base The base shall be constructed of galvanized steel for improved rigidity. Base corners shall be welded to provide strength and support for hinging and cleaning and to prevent leakage into the building. Wheel The fan wheel than be centrifugal backward inclined and non-overloading. Wheels shall be balanced in two planes and done in accordance with AMCA standard 204-96, Balance Qualify and Vibration Levels for Fans .The wheel blades shall be aerodynamically designed to minimize turbulence, increase efficiency and reduce noise. The wheel blades shall be welded to the wheel inlet cone. In the event that balancing weights are required they shall be riveted to the blades Or wheel. The wheel inlet shall overlap the fan base inlet for Maximum performance and effidency. The wheel shall be firmly attached to the motor shaft with two setscrews. Motor & Motor Compartment Standard 115 volt, open drip motors shall be permanently lubricated, rated for continuous duty and thermally protected. Motors shall be mounted out of the airstream and furnished at the specified voltage, phase and enclosure. Motor mounting plate shall be constructed of heavy gauge galvanized steel. The motor compartment shall be cooled by outside air drawn through an extruded aluminum conduit tube. To seal the conduit tube passage and prevent noise silieone rubber grommets shall isolate the conduit tube from the fan housing. The motor compartment shall be of a two-piece construction with the cep having quick release clips to provide quick and easy access to the motor compartment Grease Spout A grease spout made of aluminum tubing shall be welded to the fan housing. The weld shall be factory tested to ensure it will not leak. Nylon Washers To provide a tight seal all fasteners in the fan housing shall be backed with nylon washers. Product: Fan shall be model VXD as manufactUred by Ventilation Direct.