Laserfiche WebLink
Ins"lation Instructions <br />FITLS-350 <br />." <br />SECTIONI MONITOR B. GENERAL WIRING PRACTICES. <br />1. Locate and mark mounting points at the location se- <br />lected in Section 3.0 (refer to Figure 8, "Monitor Di- <br />mensions and Mounting Requirements"). <br />BE SURE TO CONSIDER THE WEIGHT OF THE <br />CONSOLE AND THE MOUNTING SURFACE MA- <br />TERIAL WHEN SELECTING A MOUNTING FAS- <br />TENER. <br />If the fastening device requires an insert in the mount- <br />ing surface, drill the appropriate holes and install the <br />inserts. Up to 1/4" screws or bolts may be used. <br />Mount the monitor to the mounting surface through <br />the holes in the four mounting flanges located on the <br />top and bottom of the monitor. <br />Connect the power wiring conduit and probe and sen- <br />sor wiring conduit(s) in the appropriate knockouts. <br />14 <br />Wiring the TLS -350 is not complicated; however, it is <br />essential for your safety and for proper operation of the <br />system that you observe all warning statements and care- <br />fully follow the instructions in this manual. <br />Here are a few general guidelines to help insure a success- <br />ful installation. <br />1. Be sure all wires entering the TLS -350 monitor are <br />color coded or marked to identify their source. <br />2. Each module comes with a terminal connector. Do not <br />remove the connector from the module during <br />wiring. <br />Terminal identifications appear only on the module <br />bracket. Removing the connector for wiring increases <br />the risk of connecting wires to the wrong terminals. <br />3. Label all connectors according to the number of the slot <br />in which their modules are installed. A sheet of <br />self-adhesive number labels is supplied with each sys- <br />tem and with each module. <br />4. Record all required wiring information on the circuit <br />directory located on the back of the right-hand door. <br />(See Figure 10, "Circuit Directory - Example.") <br />