Laserfiche WebLink
Monitoring System Certification <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 0.75 <br /> Complete the following checklist: <br /> 0 Yes E3 No* Is the audible alarm operational? <br /> 0 Yes 0 No* Is the visual alarm operational? <br /> 10 Yes 0 No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> 0 Yes 0 No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> 0 <br /> 0 Yes ❑ No Talarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br /> IV <br /> N/A operational? <br /> 0 Yesβ€” ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) 0 Sump/Trench Sensors; 0 Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to-leaks and sensor failure/disconnection? 0 Yes; [I No. <br /> El Yes 0 No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e., no <br /> 0 N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fL62M fill point(s) does the alarm trigger? 90% <br /> 0 :Yes* 0 No Was any in <br /> 0 No* <br /> NIA <br /> s <br /> a <br /> an, at ha percent tank capacity <br /> c <br /> sensors, <br /> enso <br /> n Section.specific <br /> of <br /> F" d operating <br /> properly? <br /> If <br /> ' w rt <br /> L op tm <br /> 0 No it in equipment <br /> e a ed If es probes,or other equipment replaced <br /> an p <br /> t <br /> or g uipm r P' c ? y identify <br /> manufacturer <br /> f <br /> and list the turer name d de or all replacement en tion E,below. <br /> tsystems <br /> ms designed <br /> ta r s <br /> a 0 <br /> uf <br /> f <br /> 0 Yes* 0 No Was liquid found inside any second containment <br /> on en e de ed a <br /> 0 W If v systems? (Check all that apply) <br /> Z Product; ater. yes,describe causes in Section E,below. <br /> Yes El No* . -_ as monitoring ---system set-up reviewed to ensure proper settings?Attach set up reports,if applicable <br /> Yes El No* Is all monitoring equipment operational <br /> per---manufacturer's specifications? <br /> In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: Dispensers have stand-alone sensors. Found small amount of Diesel product inside the UDC on#1&2. <br /> Page 2 of 3 <br />