ARCHIVED REPORTS_XR0011943 - Laserfiche WebLink

Home Browse Search

�I SAMPLING AND ANALYSIS PROCEDURES The sampling and analysis procedures as well as the quality assurance pian are contained in this appendix The procedures and adherence to the quality assurance plan will provide for consistent and reproducible sampling methods, proper application of analytical methods, accurate and precise analytical results, and finally, these procedures will proA ide guidelines so that the o-,erall objectives of the monitoring program are achieved Gz ound N-Vater and Liquid-Phase Petroleum Hydrocarbon Depth Assessment A -,atei/hydiocazbon interface probe is used to assess the liquid-phase petroleum hydrocarbon (LPH) thickness, if present, and a water level indicator is used to measure the ground water depth in monrtoirng wells that do not contain LPH Depth to ground water or LPH is measured from a datum point at the top of each monitoring well casing The datum point is typical a notch cut in the north side of the casing edge If a water level indicator is used, the tip is subjectively analyzed for hydrocarbon sheen Subjective Analysis of Ground Water Prior to purging, a water sample is collected from the monitoring well for subjective assessment The sample is retrieved by gently lowering a clean, disposable bailer to approximately one-half the bailer length past the air/liquid interface The bailer is then retrieved, and the sample contained within the bailer is examined for floating LPH and the appearance of a LPH sheen Monitoring Well Purging and Sampling Monitoring wells are purged using a pump or bailer until pH, temperature, and conductivity of the purge water has stabilized and a minimum of duee well volumes of water have been removed If three well volumes can not be removed in one half hour's time the well is allowed to iechaige to 80% of oiiginal level After recharging, a ground water sample is then removed from each of the yells using a disposable bailer A Teflon bailer, electric submersible or bladder pump will be the only equipment used for well sampling When samples for volatile organic analysis are being collected, the pump flow «rill be regulaica at appioxirnateiy 100 milliliters per minute to minimize pump effluent turbulence and aeration Glass bottles of at least 40-milliliters volume and fitted with Teflon-lined septa will be used in sampling fon volatile organics These bottles «ill be filled completely to pi event air from remaining in the bottle A positive meniscus forms «hen the bottle is completely full A convex Teflon septum vs ill be placed over the posits e meniscus to eliminate all After the bottle is capped, it is inverted and tapped to verify that it contains no air bubbles The sample containeis for other • parameters t ill be filled filtered as required and capped Pane 1