|
MSDS 7
<br /> July 1,2002
<br /> YELLOW IRON OXIDE Engineering controls and work practices:
<br /> Eye contact may cause any oft e following:mechanical irritation Ventilation:
<br /> Provide sufficient ventilation in volume and pattern to keep
<br /> SECTION 4-First Aid Measures contaminants below applicable exposure limits.
<br /> Respiratory:
<br /> First Aid Procedures: Do not breathe vapors or mists. Wear a properly fitted
<br /> Inhalation: air-purifying respirator with organic vapor cartridges(NIOSH approved
<br /> If affected by inhalation of vapo or spray mist,move to fresh air. TC-23C)and particulate filter(NIOSH TC-84A)during application and
<br /> If not breathing,give artificial respiration,preferably until all vapors and spray mists are exhausted. In confined spaces,
<br /> mouth-to-mouth. If breathing d fficulty persists,or occurs later, or in situations where continuous spray operations are typical,or if
<br /> consult a physician, proper air-purifying respirator fit is not possible,wear a positive
<br /> Ingestion: pressure,supplied-air respirator(NIOSH TC-19C). In all cases,
<br /> In the unlikely event of ingestion,DO NOT INDUCE VOMITING. Call follow respirator manufacturers directions for respirator use.Do
<br /> a physician immediately and hav a names of ingredients available. not permit anyone without protection in the painting area.
<br /> Skin or eye: Protective clothing:
<br /> In case of eye contact, immediately flush with plenty of water for at Neoprene gloves and coveralls are recommended.
<br /> least 15 minutes;call a physician.In case of skin contact,wash Eye protection:
<br /> thoroughly with soap and water.If irritation occurs,contact a Desirable in all industrial situations.Goggles are preferred to
<br /> physician. prevent eye irritation. If safety glasses are substituted, include
<br /> splash guard or side shields.
<br /> SECTION 5-Firefighting Measures
<br /> Flash Point(Closed Cup) See Section 11 for exact values. SECTION 9-Physical and Chemical Properties
<br /> Flammable limits LFL 0.0%UFL 13.1% Evaporation Rate Slower than Ether
<br /> Extinguishing media: Solubility in water NIL
<br /> Universal aqueous film-forming fc am,carbon dioxide,dry chemical. Vapor Density Heavier than air
<br /> Fire fighting procedures: Approx.boiling range('C) No Data Available
<br /> Full protective equipment, includi g self-contained breathing Approx.freezing range('C) -92--83'(C)
<br /> apparatus,is recommended.Wat r from fog nozzles may be used to Gallon weight(lbs./gal) 8.14- 11.50
<br /> prevent pressure build-up. Specific gravity 0.98- 1.38
<br /> Fire&explosion hazards: Percent volatile by volume 51.11- 70.33
<br /> For flammable liquids,vapor/air ill ignite when an ignition source Percent volatile by weight 42.81- 65.00
<br /> is present. In other cases,when heated above the flash point,emits Percent solids by volume 29.67- 48.89
<br /> flammable vapors which,when m xed with air,can burn or be Percent solids by weight 35.00- 57.19
<br /> explosive.Fine mists or sprays may be flammable at temperatures
<br /> below the flash point. SECTION 10-Stability and Reactivity
<br /> SECTION 6-Accidentalelease Measures Stability:
<br /> Stable
<br /> Steps to be taken in case material is re aced or spilled: Incompatibility(materials to avoid):
<br /> Ventilate area. Remove sources o ignition. Prevent skin and eye None reasonably foreseeable
<br /> contact and breathing of vapor. Wear a properly fitted air-purifying Hazardous decomposition products:
<br /> respirator with organic vapor cartr dges(NIOSH approved TC-23C), CO,CO2,smoke,and oxides of any heavy metals that are reported in
<br /> eye protection,gloves and protective clothing.Confine,remove with "Composition,Information on Ingredients"section.
<br /> inert absorbent,and dispose of properly. Hazardous polymerization:
<br /> Will not occur.
<br /> SECTION 7-Handling and Storage Sensitivity to static discharge:
<br /> For flammable materials(flashpoint less than 1000F)and
<br /> Precautions to be taken in handling and storing: combustibles(flashpoint between 100-200'F)if heated above the
<br /> Observe label precautions.If comb istible(flashpoint between 100- flashpoint,solvent vapors in air may explode if static grounding and
<br /> 200'F),keep away from heat,spar Ks and flame.If flammable bonding is not used during transfer of this product.
<br /> (flashpoint less than 100'F),also k ep away from static Sensitivity to mechanical impact:
<br /> discharges and other sources of igr ition.If material is extremely Not Applicable
<br /> flammable(flashpoint less than 20"F)or flammable,VAPORS MAY
<br /> IGNITE EXPLOSIVELY OR CAUSE FLASH FIRE,respectively.Vapors SECTION 11-Additional Information
<br /> may spread long distances.Preven buildup of vapors.Close container
<br /> after each use.Ground containers when pouring.Wash thoroughly PRODUCT CODE INGREDIENTS(Product Specific)
<br /> after handling and before eating or smoking.Do not store above
<br /> 1207. If product is waterbased,do not freeze. 520UT" Acrylic Polymer-A,Aluminum(10%*),Aromatic Hydrocarbon,
<br /> Other precautions: Ethylbenzene(0.9%*@),Medium Mineral Spirits,N-Butyl Alcohol(3%*),
<br /> If material is a coating:do not sanflame cut,braze or weld dry Petroleum Naphtha, Propylene Glycol Monomethyl Ether Acetate,Xylene
<br /> coating without a NIOSH approved espirator or appropriate (4-5%*@)
<br /> ventilation,and gloves. GAL WT:8,64 WT PCT SOLIDS:47.74 VOL PCT SOLIDS:39.33
<br /> SECTION 8-Exposure Controls¢r Personal Protection SOLVENT DENSITY:7.44 VOC LE: 4.5 VOC AP: 4.5
<br /> FLASH POINT:730F to below 100'F H:2 F:3 R.1 OSHA STORAGE:IC
<br /> 5
<br /> MSDS 7
<br /> July 1, 2002
<br /> © 2001-2002 E.I. du Pont de Nemours and Company.All rights reserved. Reproduction or translation of any part of this
<br /> work beyond that permitted by U.S.copyright laws without the written permission of du Pont is
<br /> unlawful and strictly forbidden.
<br />
|