Laserfiche WebLink
r , <br /> 2 3.02 INSTALLATION <br /> 3 <br /> 4 A. Surface Preparation: <br /> s <br /> 6 a. Allow new concrete block and concrete to cure for a minimum of thirty days before <br /> 7 being coated. <br /> 8 <br /> s b. Moisture content to be no higher than 15 percent as registered on an electronic <br /> 10 moisture meter. <br /> 11 <br /> 12 c. All cracks, other than hairline cracks to be tuck-pointed or caulked. All voids and bee <br /> 13 holes in masonry units shall be filled. Defective mortar joints shall be routed out and <br /> 14 pointed with mortar, or caulked and tooled. <br /> 15 <br /> 16 d. Remove any soil, mud, efflorescence, excessive mortar, etc. Use •dry' cleaning <br /> 17 method, if possible. If wet cleaning is required, allow adequate time in drying. <br /> 18 <br /> 19 e. Sealer shall be applied under factory supervision, and shall be warranted to perform <br /> r 20 for five years. <br /> 21 <br /> 22 B. Installation: Install the waterproofing in strict accordance with the manufacturer's <br /> 23 recommendations, covering all surfaces where waterproofing will be required to prevent <br /> 24 penetration of moisture through the building shell; install the required protective covering <br /> 25 over the waterproofing to prevent damage during backfill operation. <br /> 26 <br /> 27 <br /> ze <br /> 29 END OF SECTION <br /> r <br /> 1 <br /> 1 <br /> r <br /> rWATERPROOFING <br /> 050694 07100-3 <br /> r <br />