Laserfiche WebLink
2.2 NAMEPLATES AND TAGS <br /> ' A. Equipment exterior nameplates-Nameplate material shall be rigid laminated black phenolic <br /> with bevelled edges and white lettering; except for caution, warning, and danger nameplates <br /> the color shall be red with white lettering. The size of the nameplate shall be as shown on the <br /> drawings. No letters are allowed smaller than 3/16". Securely fasten nameplates in place <br /> ' using two stainless steel screws if the nameplate is not an integral part of the device. Epoxy <br /> cement or glued on nameplates will not be acceptable. Engrave the nameplates with the <br /> inscriptions as approved by the Owner Engineer in the submittal. <br /> ' 1. For each major piece of electrical equipment provide a manufacturer's nameplate <br /> showing the Contract specified name and number designation, the manufacturer's name, <br /> model designation, part number, serial number, and pertinent ratings such as voltage, <br /> amperage, # of phases, range, calibration, etc. <br /> ' 2. For each device with a specific identity(pushbutton, indicator, instrument, etc.) mounted <br /> on the exterior or deadfront of a piece of equipment provide a nameplate with the <br /> inscription as shown in the Contract documents. Where no inscription is indicated in the <br /> Contract documents, furnish nameplates with an appropriate inscription providing the <br /> name and number of device. <br /> ' B. Equipment Interior Nameplates- Nameplate material shall be clear plastic with black machine <br /> printed lettering as produced by a KROY or similar machine; except caution, warning, and <br /> danger nameplates shall have red lettering. The size of the nameplate tape shall be no smaller <br /> ' than 1/2" in height with 3/8" lettering unless otherwise approved by the Owner Engineer. <br /> Securely fasten nameplates in place on a clean surface using the adhesion of the tape. Add <br /> additional clear glue to hold the nameplate securely in place when necessary. For each device <br /> with a specific identity (relay, module, power supply, fuse, terminal block, etc.) mounted in <br /> the interior of a piece of equipment provide a nameplate with the inscription as shown in the <br /> Contract documents. Where no inscription is indicated in the Contract documents, furnish <br /> nameplates with an appropriate inscription providing the name and number of device used on <br /> the submittal drawings. Stamp the nameplates with the inscriptions as approved by the Owner <br /> ' Engineer in the submittal. <br /> ELECTRICAL <br /> 16000 - 13 <br /> i <br />