Laserfiche WebLink
OMTM QABSAttY OF OC Vak DATA <br /> Uk <br /> U - Ccupound was analyzed for bort not detected. The associated <br /> mmierical value is the estimated sarple quantitation limit <br /> which is included and corrected for dilution and percent <br /> moisture. <br /> J = <br /> Indicates an estimated value. This flag is used either when <br /> estimating a concentration for tentatively identified <br /> aampouuds where a 1:1 response is assumed or when the mass <br /> spectral data indicate the presence of a oampourd that meets <br /> the identification criteria but the result is less than the <br /> specified detection limit but greater than zero; for example, <br /> if the limit of detection is 10 ug/L and a concentration of 3 <br /> ug/L is calculated, it is reported as 3J. <br /> B = This flag is used when the analyte is found in the associated <br /> blank as well as in the sample. It indicates <br /> possible/probable blank contamination. This flag is also used <br /> for a TIC as well as for a positively identified 'TCL compound. <br /> E = Indicates that the ccupouxi was detected beyond the <br /> calibration range and was s,tzerquently analyzed at a dilution. <br /> I -- Interference. <br /> N = Not Confirmed. <br /> Y = Confirmed Positive. <br /> ABBREVIA 7-CNS <br /> BS = Indicates blank spike in which reagent grade water is spiked <br /> with the CLP matrix spiking solutions and carried through all <br /> the steps in the method. Spike recoveries are reported. <br /> BSD = Indicates blank spike duplicate. <br /> MS = Indicates matrix spike. <br /> NASD = Indicates matrix spike duplicate. <br /> DL = Irdicates that surrogate recoveries were not ebtained because <br /> the Fxtract had to be diluted for analysis. <br /> NA = Not applicable. <br /> DF = Dilution factor. <br /> NR = Not regAr d. <br />