Laserfiche WebLink
Qr065ARY OF OC VCA DATA <br /> DATA <br /> U = Ccupouni was analyzed for but not detected. Mie associated <br /> numerical value is the estimated sample quantitation lout <br /> which is included and corrected for dilution and percent <br /> moisture. <br /> J = Indicates an estimated value. This flag is used either when <br /> estimating a concentration for tentatively .identified <br /> corqDounds where a 1:1 response is assumed or when the mass <br /> spectral data indicate the presence of a coupound that meets <br /> the identification criteria but the result is less than the <br /> specified detection licit but greater than zero; for exanple, <br /> if the lout of detection is 10 ug/L arra a oonaentratton of 3 <br /> ug/L is calculated, it is reported as 3J. <br /> B - This flag as used when the analyte as found in the associated <br /> blank as well as in the sample. It indicates <br /> possible/probable blank contamination. This flag is also used <br /> for a TIC as well as for a positively identified TCL ccnpound. <br /> E = Indicates that the ccapo Ynd was detected beyond the <br /> calibration range and was subsequently analyzed at a dilution. <br /> • I = Interference. <br /> N - Not Confirmed. <br /> Y = Confirmed Positive. <br /> ABBREVIATIONS <br /> BS = Indicates blank spike in which reagent grade water is spiked <br /> with the CLP matrix spiking solutions and carried through all <br /> the steps in the method. Spike recoveries are reported. <br /> BSD = Indicates blank spike duplicate. <br /> MS = Indicates matrix spike. <br /> MSD = Indicates matrix spike duplicate. <br /> DL = Indicates that surragate recoveries were not obtained because <br /> the extract had to be diluted for analysis. <br /> NA = Not applicable. <br /> . DF = Dilution factor. <br /> NR = Not required. <br />