Laserfiche WebLink
Installation <br /> Dual-Point Hydrostatic Sensor Installation <br /> 1. Turn Off power to the console. <br /> 2. Lower the sensor into the riser until it rests on the bottom of the reservoir(see Figure 2). Note:Refer to the tank <br /> manufacturer's instructions for setting the proper brine levels.The ideal brine solution level is approximately halfway <br /> between the high and low water levels.With the Dual-Point Sensor resting on the inner-tank wall,the sensor will <br /> alarm when the brine level is below 2"or when the brine level is above 12". <br /> 14" min. dia. Cord Weatherproof <br /> manhole\ grip junction box <br /> o..a <br /> An'l v vc�n°+aav <br /> Riser pipe Seal-off <br /> cap <br /> Dual-point \1/2" rigid <br /> hydrostatic conduit <br /> sensor (to console) <br /> Float <br /> Reservoir <br /> Brine <br /> level .� Double-wall <br /> ---- -- tank <br /> -------------- <br /> sensors\hssenap.eps <br /> Figure 2. Dual-Point Sensor Installation(shown with plastic riser cap) <br /> 3. Riser Cap Installation <br /> a. If you have the plastic riser cap kit <br /> Place the cord grip bushing into either of the threaded fittings in the plastic cap and screw the cord grip nut over <br /> the bushing. With the nut loose,push the end of the sensor cable through the cord grip.Place the cap in the riser <br /> and snap down the cap lever to seat the gasket against the inside of the pipe.Screw the vent cap from the kit down <br /> snugly onto the other threaded fitting of the riser cap. <br /> b. If you have the metal riser cap and vent tube <br /> Install the vent tube into one of the cord grips in the metal riser cap(ref.Figure 5 on page 7)and tighten the cord <br /> grip.Loosen the other cord grip and push the sensor cable through it.Place the cap in the riser and snap down the <br /> cap lever to seat the gasket against the inside of the pipe. <br /> 4. With the sensor still resting on the bottom of the reservoir,leave a little slack in the sensor cable and tighten the cable <br /> cord grip nut. <br /> 5 <br />