INSTALL_2011 - Laserfiche WebLink

Home Browse Search

Veeder-Roof Line Leak Application Guide Special Installations Manifolded Line Applications PLLD and WPLLD leak detection systems can handle product lines supplied by multiple tanks and pumps,to a maximum of 8 tanks and pumps per product line. Standard line leak sensing and check valve equipment should be installed at the primary pump. To perform 0.2 and 0.1 gph tests, a non-vented SwiftCheck valve(P/N 330020-416), or new Red Jacket 65 psi relief valve(P/N 410153-002),or SpikeCheck Valve Non-PSI Relief Valve for Standard Pump(P/N 410557-002), or FE Petro 65 psi Relief Check Valve(FE P/N 402459931)should be installed on each of the other pumps supporting the manifolded product line.The Non- Vented SwiftCheck Valve is rated to a maximum 70 gpm. NOTE: For 5 HP Maxxum pumps in diesel,an addtional in-line check valve with no pressure relief should be installed • on the`Slave'pump to prevent backflow. A relay on a Four-Relay module or 1/0 Combination module(TLS-350)or 1/0 Module(TLS-450) must be available to control each secondary pump.The standard line leak modules will provide pump control output for the primary pump and the"Pump In" signal for the set. A typical manifolded line installation for PLLD is shown below: To Dispensers Flexible Pipe with Flexible Pipe with Swivel or Union Swivel or Union Ball Valve Ball Valve Non-Vented PLLD Sensor/ SwiftCheck SwiftCheck Valve Valve(if req'd.) Assembly B 1320 . a • ❑ ❑ Warning Tag Master Pump Slave Pump p11tl\rnfd1anks.eps Lower Numbered Tank Higher Numbered Tank Transducer Installation - Red Jacket CPT and Quantum CPT Pumps This installation procedure is to be used with Red Jacket CPT and Quantum CPT Pumps. 1. Install the Red Jacket CPT Transducer Adapter Kit(Red Jacket part number 144-326-5)following the instructions with the kit.Thread the PLLD transducer in the mechanical LLD port of the pump. QIMPORTANT!Seal any pipe threads using a UL-classified,nontoxic pipe sealant suitable for the fuel involved. • The figure below illustrates two PLLD transducer installations in Red Jacket CPT pumps-consult"Check Valve Require- ments"on page 5,to determine what check valve you will need to install to perform your intended level of testing. 2. Verify that the TLS-350 Console has Version x19 or later(TLS-450 has Version 1 or later)software. 10