INSTALL_2011 - Laserfiche WebLink

Home Browse Search

Introduction General This manual contains instructions to connect a Veeder-Root TLS-350R Console to Wayne or Bennett current loop dispenser controllers.Components you will install include a Current Loop Dispenser Interface Module(CDIM),Cable Adapter Boxes(CABs), and interconnection cables. Wayne / Bennett CDIMs and Installation Kits Wayne and Bennett CDIMs and installation kits discussed in this manual are shown in Table 1. Table 1.- Wayne/Bennett CDIM and Installation Kit Guide Dispenser DIM PIN • DIM Install Dispenser POS Type w/console as Upgrade Cable Length(ft) Kit PIN Notes 5 848703-0051 10 848703-0101 A Wayne site controller and Wayne dispensers are Wayne Site 847490-410 25 848703-0251 required.Any POS may be Wayne Controller 330404-010 (CDIM) connected to the Wayne site 50 848703-0501 controller.All Wayne electronic blenders are supported includ- 100 848703-1001 ing Nucleus. 200 848703-2001 5 848705-0052 10 848705-0102 For Bennett 92D controllers. 847490-440 25 848705-0252 DIM kit has 2 CABs in it.One Bennett 92D 330404-040 (CDIM) CAB is needed per current 50 848705-0502 loop.Only one or two dispens- ers are on one current loop. 100 848705-1002 200 848705-2002 1 Kits contain 2 CABs,two 6-ft CAB-to-dispenser controller cables(P/N 331105-001),and two CAB-to-console cables(P/N 330592-XXX). 2Kits contain 2 CABs,two 6-ft CAB-to-dispenser controller cables(P/N 331105-001),two CAB-to-console cables(P/N 330592-XXX),and 2 wirenuts. Wayne CDIM Operating Requirements The following equipment is required to interface to a Wayne POS System: I. TLS-350R with BIR Console(Memory Expansion Module,Part 330532-001 is required in the console for siphon-mani folded tanks,or for more than 8 tanks). 2. One Wayne CDIM for up to 24 fueling positions(see Table I on page 1). 3. One Wayne DIM Installation Kit(see Table 1 on page 1). 1