Laserfiche WebLink
Introduction <br /> This manual contains installation procedures for the Veeder-Root Overfill Alarm and Acknowledgement(Ack)Switch. <br /> The Overfill Alarm unit contains: <br /> • Red flashing light <br /> • Alarm horn <br /> The Acknowledgement Switch unit contains: <br /> • ACKNOWLEGED light <br /> • RESET push button <br /> • TEST push button <br /> Compatible Consoles <br /> • TLS-3XX/4XX Series <br /> • TLS-IB <br /> • TLS-50 <br /> • TLS-HLD <br /> • TLS2 <br /> Related Manuals <br /> Depending on your installed console,you should reference the appropriate manuals below,to connect/setup the Overfill <br /> Alarm: <br /> 576013-879 TLS-3XX Series Site Prep Manual 576013-623 TLS-3XX Series Setup manual <br /> 577013-608 TLS-50 Site Prep manual 577013-609 TLS-50 Setup manual <br /> 577013-756 TLS2 Site Prep manual 577013-757 TLS2 Setup manual <br /> 577013-719 TLS-IB Site Prep manual 577013-785 TLS-HLD Setup manual <br /> 577013-784 TLS-ULD Site Prep manua 577013-879 TLS-4XX Site Prep Manual <br /> Contractor Certification Requirements <br /> Veeder-Root requires the following minimum training certifications for contractors who will install and setup the <br /> equipment discussed in this manual: <br /> Level 1 Contractors holding valid Level 1 Certification are approved to perform wiring and conduit routing, <br /> equipment mounting,probe and sensor installation,tank and line preparation,and line leak detector <br /> installation. <br /> Level 2/3 Contractors holding valid Level 2 or 3 Certifications are approved to perform installation checkout, <br /> startup,programming and operations training,troubleshooting and servicing for all Veeder-Root Tank <br /> Monitoring Systems,including Line Leak Detection and associated accessories. <br /> Warranty Registrations may only be submitted by selected Distributors. <br /> 1 <br />