INSTALL_2011 - Laserfiche WebLink

Home Browse Search

Bulletin No. B2108 July 1, 2005 FiberCMdssefns ger SMITH FIBERCAST STAR • SMITH • FIBERCAST Sump Entry/Termination Fitting with Bonded Fiberglass Alignment Rings 2. Using 4o-6o grit sanding surface, Locate the 1/4"threaded outlet to sand the area around the hole where the desired location. Leave 1/4" the alignment rings will bond to the plastic threaded outlet protector in sump. Lightly sand the rings. place until 1/4"fitting installation. Remove dust and wipe with solvent 4. Dry fit primary pipe and rotate the (optional). two rings until the desired angle is 3. Place two alignment rings on sump reached. Make alignment marks entry/termination fitting and on the rings,the fitting, and the insert through sump wall with the sump wall. rings on the outside of the wall. Note: Fiberglass alignment rings can Entry/Termination Fitting Body only be bonded to a flat fiberglass sur- /-Sump Wall face.DO NOT install on round sumps. Alignment Rings 1. Determine entry hole location and cut entry hole in sump wall using dimensions in Table 1.(Maximum allowable offset is 50.) Outside Sump C Inside Sump TABLE 1. Fitting Dimensions Hae Dia Size A B C in. in. in. in 3x2 6.83 4.00 4.00 B Retaining Ring 40 6.83 4.00 5.00 A 5. Place one ring over the dhesive Bead sump fitting in the inside of Adhesive Bead the sump and rotate to the desired angle. Make align- ment mark on both the Im sump wall and the ring. -_ - --- 6. Mix one 7014 or 8o14 adhesive for each fitting ! per the instructions in j the adhesive kit.Mix in -•- --.___---- -- '- -_•- -•---__ ---____ filler to thicken adhesive (fiberglass alignment ring will not seal properly without filler). Retaining Ring 7. Apply adhesive generous- ly,approximately 1/16" (over) URL http://www.smithfibercast.com FIBER GLASS SYSTEMS•A NATIONAL OILWELL VARCO COMPANY 2700 W.65TH ST.,LITTLE ROCK,AR 72209-8592•Phone 501-56814010•Fax 501-5684465 25 S.MAIN ST.,SAND SPRINGS,OK 74063•Phone 918-245-6651•Fax 918-245-7566