Laserfiche WebLink
Installation Instructions for Snap Seal Inclinometer Casing <br /> Installation Method: <br /> 1. Insert a weight into the bottom of the sheath with the groove side down, leaving room for the <br /> installation of the end cap. <br /> 2. Slide 2 band clamps over the sheath and tighten so that the clamps squeeze the sheath into the <br /> grooves locking the weight into place. <br /> 3. Install the End Cap onto bottom of the sheath. <br /> 4. Seal with Denso tape and Duct tape. <br /> 5. Lower Corrugated Settlement Sheath Pipe into the borehole. <br /> Note: Ballasting the pipe with clean water may be necessary to counter the buoyancy <br /> encountered with wet bore holes. <br /> 6. Install Inclinometer casing inside the Corrugated Settlement Sheath Pipe. <br /> 7. Eliminate any slack by pulling on it by hand (hold in place while performing step 8). <br /> 8. Fill the void between the sheath and borehole with grout, ensuring that no grout gets into the <br /> sheath or casing. <br /> 9. If Corrugated Settlement Sheath is equipped with settlement rings, then lower the sensor into the <br /> casing and record the initial readings of each Settlement Ring. Refer to the RST Instruments <br /> Manual "Settlement Monitoring System". <br /> 13 <br />