Laserfiche WebLink
KL EINFELDER <br /> ATTACHMENT B <br /> KLEINFELDER FIELD PROTOCOL <br /> B-I FIELD PREPARATION <br /> Before performing work in the field, environmental staff review the scope of work, prepare a <br /> health and safety plan, coordinate the work to be done with their supervisor, assemble the <br /> necessary sample containers, and check, calibrate and clean equipment to be used in the field. <br /> When underground utilities may exist at a site where subsurface soil samples are being collected, <br /> USA Underground is contacted with the boring locations and the scheduled date of drilling, or a <br /> utility locating firm is employed to check the boring locations. <br /> B-2 SUBSURFACE SOIL SAMPLING <br /> B-2.1 Drilling <br /> Subsurface soil samples are collected from soil borings. Soil borings are advanced using a truck- <br /> mounted drill rig, equipped with 8-inch hollow stem augers. The borings can be advanced <br /> vertically, or at an angle up to 45 degrees from vertical. During drilling, an experienced <br /> environmental geologist classifies the soil, logs the lithology and collects soil samples for <br /> laboratory analysis. A sample boring log form is attached at the end of this appendix. <br /> B-2.2 Decontamination of Equipment <br /> To reduce the potential for cross-contamination, augers and associated equipment are steam <br /> cleaned prior to drilling each boring. In addition, sampling equipment is cleaned with a <br /> trisodium phosphate wash and rinsed with distilled water prior to collecting each soil sample. <br /> B-2.3 Collection of Soil Samples <br /> Soil samples are collected approximately every 5 feet for field screening, lithologic logging, and <br /> potential chemical analysis. Samples are collected by advancing the boring to a point <br /> immediately above the desired sampling depth and then driving (vertical borings) or pushing <br /> (slant borings) a Modified California Sampler, lined with three brass tubes, into the undisturbed <br /> soil. The sampler is then removed from the bottom of the boring. The ends of the bottom (third) <br /> tube are covered with Teflon and sealed with tight-fitting plastic caps. <br /> 20-3978-01.W3 5/201712491 Page No. B-I <br /> Copyright 1997. Kleinfelder. Inc. October 4, 1997 <br />