ARCHIVED REPORTS_COMBINED ANNUAL AND FOURTH QUARTER 2016 GROUNDWATER MONITORING REPORT

Home Browse Search

NELAP/ORELAP Certification 4036 IL Caltest CA-ELAP Certification 1664 ANALYTICAL LABORATORY ENVIRONMENTAL ANALYSES NARRATIVE Lab Order: R100280 Project ID: DIAMOND PET RIPON/388065 General Qualifiers and Notes Caltest authorizes this report to be reproduced only in its entirety.Results are specific to the sample(s)as submitted and only to the parameter(s)reported. Caltest certifies that all test results for wastewater and hazardous waste analyses meet all applicable NELAC requirements;all microbiology and drinking water testing meet applicable ELAP requirements,unless stated otherwise. All analyses performed by EPA Methods or Standard Methods(SM)20th Edition except where noted(SMOL=online edition). Caltest collects samples in compliance with 40 CFR, EPA Methods,Cal.Title 22,and Standard Methods. Dilution Factors(DF)reported greater than'1'have been used to adjust the result, Reporting Limit(RL),and Method Detection Limit(MDL). All Solid,sludge,and/or biosolids data is reported in Wet Weight,unless otherwise specified. Filtrations performed at Caltest for dissolved metals(excluding mercury)and/or pH analysis are not performed within the 15 minute holding time as specified by 40CFR 136.3 table II. Results Qualifiers: Report fields may contain codes and non-numeric data correlating to one or more of the following definitions: ND-Non Detect-indicates analytical result has not been detected. RL-Reporting Limit is the quantitation limit at which the laboratory is able to detect an analyte.An analyte not detected at or above the RL is reported as ND unless otherwise noted or qualified. For analyses pertaining to the State Implementation Plan of the California Toxics Rule,the Caltest Reporting Limit(RL)is equivalent to the Minimum Level(ML).A standard is always run at or below the ML.Where Reporting Limits are elevated due to dilution,the ML calibration criteria has been met. J-reflects estimated analytical result value detected below the Reporting Limit(RL)and above the Method Detection Limit(MDL). The'J'flag is equivalent to the DNQ Estimated Concentration flag. E-indicates an estimated analytical result value. B-indicates the analyte has been detected in the blank associated with the sample. NC-means not able to be calculated for RPD or Spike Recoveries. SS-compound is a Surrogate Spike used per laboratory quality assurance manual. NOTE:This document represents a complete Analytical Report for the samples referenced herein and should be retained as a permanent record thereof. 10/20/2016 05:17 REPORT OF LABORATORY ANALYSIS Page 3 of 8 This report shall not be reproduced,except in full, AC without the written consent of CALTEST ANALYTICAL LABORATORY 1885 North Kelly Road•Napa, California 94558 �s q (707)258-4000 •Fax(707) 226-1001 • e-mail: info@caltestlabs.com ■� e