COMPLIANCE INFO_2020 - Laserfiche WebLink

Home Browse Search

5 . Place the remaining ring over the sump entry fitting in 10 . Do not disturb assembly until the adhesive is cured . the inside of the sump and rotate to the desired angle . This includes bonding of pipe to the sump entry fitting Make alignment mark on both the sump wall and the ring and installing the threaded outlet fitting . See adhesive kit when at the desired angle to make the "free " surface of the instructions for cure times . ring as close to perpendicular (square) to the axis of the fitting as possible . 11 . The use of an industrial hot air gun may speed up the curing process . Do not overheat . 6 . Mix one 8oz PSX 20 or one 8069 adhesive for each fitting per the instructions in the adhesive kit . Filler should 12 . Remove 1/4 inch plastic threaded outlet protector, be used with 8069 to insure proper sealing of alignment Apply adhesive only to the 1/4 inch fitting and screw into rings . the 1/4 inch threaded outlet . Tighten to 40 in . -Ibs . or 11/2-2 turns past hand tight . After installing the fitting , be sure the 7 . Apply adhesive generously, approximately 1 /16 inch thick , interstitial space is free from excess adhesive . Install a short to the inside and the outside of the sump walls where the hose and blow excess adhesive through the air passage . alignment rings are located . Coat the edges of the hole cut in the sump wall . Apply a thin coating of adhesive to the NOTE: Verify with testing company or monitoring bonding surfaces of the alignment rings . manufacturer if a larger thread is needed for their equipment . After the port fitting is installed , do not remove . 8 . Line up rings with alignment marks and press together firmly holding the fitting in place from the outside of the 13 . Connect only flexible tubing or hoses to the port sump . fitting . 9 . Slide the metal retaining ring over the inside section of NOTE: Tubing or hoses must be rated to full vacuum . the sump entry fitting and against the inner alignment ring until all the rings are tight against both sides of the sump Drawings below show the assembly of the fitting and wall . (A short section of 4 inch pipe may be used to drive associated pipe when using either size-over-size the metal retaining ring over the fitting) . Be sure there is an containment systems or coaxial pipe . adhesive bead visible between the rings and the sump wall . The metal ring must hold the assembly in position while the adhesive cures . If the assembly is not tight against the sump wall , firmly press the sump entry fitting against the outside sump wall while pressing the metal ring against the alignment ring on the inside . Clean excess adhesive from all bonding surfaces . ADHESIVE BEAD WON _- i I i RETAINING RETAINING RING RING 2 I'