Laserfiche WebLink
SimulProbe®Technologies, Inc. <br /> Maxi SimulProbe®Soil/Groundwater Mode <br /> 3.9 Screw the Coupling onto the bottom of the core barrel, being careful to <br /> keep you fingers back from the sharp edges of the screen. <br /> 3.10 Insert the Shoe Sleeve, male threads first, into the bottom (threaded end) <br /> of the Cover Sleeve. Attach this assembly to the bottom of the core barrel <br /> by screwing it into the Coupling. (See schematic) <br /> 3.11 Insert the Sample Catcher (fingers first) into the down-hole end of the <br /> Shoe Sleeve. When you feel a little resistance to entry as the finger come <br /> into contact with the inside of the Shoe Sleeve, just continue to push firmly <br /> and the Sample Catcher will seat into place. This procedure works for the <br /> Extension Shoe Sleeve as well. <br /> 3.12 Screw the Drive Shoe onto the bottom of the Cover Sleeve. <br /> 3.13 Place a Reed Valve onto the single barb nipple at the bottom of the Water <br /> Canister Base. <br /> 3.14 Place a black o-ring above the threads of the Water Canister Base. <br /> 3.15 Screw the Water Canister Base into the top of the Core Barrel Primary <br /> Half. <br /> 3.16 Place a Black O-Ring above the threads at the bottom of the Water <br /> Canister and screw the Water Canister into the Water Canister Base. <br /> 3.17 Wrap Teflon tape around the threads of the Upper Reed Valve Support <br /> and screw it into the base of the Sampler Head. <br /> 3.18 Wrap Teflon tape around the threads of the Hex plug and screw it into the <br /> center of the Upper Reed Valve Support <br /> 3.19 Place a Black O-Ring above the Sampler Head's threads and screw the <br /> Sampler Head into the top of the Water Canister. <br /> 3.20 Close the Drive Shoe and pull a Rubber Gooch Tube over the junction <br /> between the Core Barrel and the Drive Shoe. <br /> 4 <br />